User manual COBRA XRS 9445 QUICK START GUIDE

[. . . ] Introduction Intro Important Information and Customer Assistance Operation Customer Warranty Assistance Important Information Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio Secondary Icons transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety Alert Use of this product is not intended to, and does not, ensure that motorists or passengers will not be involved in traffic accidents. [. . . ] NOTE The rev point must be reset if you use your detector in a different vehicle. Notice ondary Icons Rev yourMain Icons to engine None the level you wish to set (recommend slightly above idle) and hold revs steady for two seconds. Intro Operation Customer None Three bars will flash in succession Installation Secondary Icons Main Icons Secondary Icons Main Icons Customer Installation Assistance Customer Assistance 1 Intro 2 Notice Operation 3 Caution Notice WarningCaution Warning Intro Customer Operation Warranty Customer Assistance Assistance Warranty Operation NOTE When initially choosing your IntelliMute activation point, a setting Notice of approximately 300 to 600 RPMs above idle is recommended. Customer Warranty Assistance You can reset the activation point at any time to fit your individual preferences and driving style. Customer Setting the IntelliMute Activation Point Assistance Your detector must be installed in your vehicle. Warranty At the desired rev level, press and release the IntelliMute button. Secondary Icons Assistance Three beeps IntelliMute Set All three bars flash three times Installation Secondary Icons Secondary Icons Customer Installation Assistance Customer Assistance 1 2 Notice 3 Caution Notice WarningCaution Warning Installation Notice Notice Caution CAUTION Do not attempt to set the rev point while driving. Warning Your vehicle should be parked and idling. NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn Off. Tone Four beeps Voice Visual Display IntelliMute must be turned On before setting the activation point. Depending on whether the unit is in Tone Alert or Voice Alert mode, you will hear a series of beeps or voice messages as you follow the steps on the next page. IntelliMute Error, E appears followed by IntelliMute Off X K Ka V S E 10 English Nothing Comes Close to a Cobra® 11 Your Detector Intro Operation Settings Customer Warranty Your Detector Intro Operation Settings Customer Assistance Warranty Assistance IntelliMute Pro IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended for use by experienced users only. OperationSecondary Icons Customer Assistance Voice/Tone Setting You can set your detector to sound alerts with either a Voice or a Tone. You can change settings by using the Mute button. In Voice Alert mode, you will first hear several tones, then a voice message announcing the type of signal detected, followed Secondary Icons by more tones. In Tone Alert mode, you will hear the tones only. The factory setting is Voice Alert mode. To Change From Voice Alert to Tone Alert While no signal Notice is being detected, press and hold the Mute button for two seconds. Tone One beep Voice Tone Alert Visual Display None When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute activation point, your detector's radar detection circuits are turned Off to prevent detection by RDDs. Customer Before IntelliMute Pro can be turned On, you must have turned On and Set the Assistance IntelliMute activation point. (See pages 9 through 11. ) Notice Warranty Installation Notice Caution CAUTION When IntelliMute Pro is On, NO radar signals will be detected and NO alerts will be given at RPMs below the IntelliMute activation point. Warning IntelliMute Button City Button Press and hold both buttons simultaneously IntelliMute Pro On To Change From Tone Alert Back to Voice Alert While no signal is being detected, press and hold the Mute button for two seconds again. Tone None Voice Voice Alert Visual Display None X K Ka V S c VG-2 and Spectre I & IV+ Alert Settings Police use radar detector detectors (RDDs) to spot users of radar detectors. Your detector is able to identify signals from VG-2, Spectre I and Spectre IV+ RDDs and can provide alerts when any of these or similar devices are in use near your vehicle. Your detector can be spotted by Spectre IV+ RDDs, but is invisible to VG-2 and Spectre I RDDs. You can choose whether you want to be alerted to VG-2 and Spectre I & IV+ RDD signals. The factory setting for VG-2 and Spectre I & IV+ alerts is Off. To Turn VG-2 and Spectre I & IV+ Alerts On and Off To Turn IntelliMute Pro On While no signal Tone is being detected, Two beeps press and hold both the IntelliMute and City buttons for four seconds. To Turn IntelliMute Pro Off Press and hold both Tone the IntelliMute and One beep City buttons for four seconds. Voice IntelliMute Pro Off Visual Display c or h will show steady Voice IntelliMute Pro On Visual Display c or h will blink While no signal is being detected, press and hold the Dim button for four seconds. Tone On = Two Beeps Off = One Beep Voice Spectre VG-2 On Spectre VG-2 Off Visual Display V will blink twice in the display V will blink once in the display 13 12 English Nothing Comes Close to a Cobra® Your Detector Intro Operation Settings Customer Warranty Your Detector Intro Operation Settings and Detection Customer Warranty Assistance Radar Alert Settings Assistance Pop Alert (continued) The detector allows you to choose whether it will show alerts on the X, K and Ku bands. The factory settings are: X Band and K Band On; Ku Band Off. Secondary Icons To Turn Pop Alert On and Off Secondary Icons To Turn X Band On and Off While no signal is Tone being detected, press X On = Two beeps and hold both the Dim and Mute buttons for four X Off = One beep seconds. [. . . ] If this product should require factory service, please call Cobra first at 773-889-3087 BEFORE sending the product. This will ensure the fastest turnaround time on any repair. Notice · Secondary Icons Notice Cobra will, without charge, repair or replace, at its option, defective 14 Band Radar/Laser Detectors, products or component parts upon delivery to the Cobra Factory Service Department, accompanied by proof of the date of first consumer purchase, such as a duplicated copy of a sales receipt. You must pay any initial shipping charges required to ship the product for warranty service, but the return charges will be at Cobra's expense, if the product is repaired or replaced under warranty. This warranty gives you specific rights, and you may also have other rights which vary from state to state. [. . . ]