User manual COBRA XRS 970

[. . . ] Introduction Important Information and Customer Assistance · Important Information Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety/Strobe Alert Use of this product is not intended to, and does not, ensure that motorists or passengers will not be involved in traffic accidents. [. . . ] When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute activation point, your detector's radar detection circuits are turned Off to prevent detection by RDDs. Before IntelliMute Pro can be turned On, you must have turned On and Set the IntelliMute activation point. (See pages 14 through 16. ) CAUTION When IntelliMute Pro is On, NO radar signals will be detected and NO alerts will be given at RPMs below the IntelliMute activation point. To Turn IntelliMute Pro On or Off Using Program Mode (See Page 7 For Instructions on Using Program Mode) To Set the IntelliMute Activation Point Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to Set IntelliMute. Press and release the Set/City button to begin setting IntelliMute RPMs. Rev your engine to the level you wish to set. Rev the engine slightly above idle and hold revs steady for two seconds. At the desired rev level, press and release the Set/City button. Press and release either the Select/Dim button to proceed to the next user mode or the Program/Mute button to exit the Program mode. Tone None Two beeps Visual Display Set IntelliMute Press SET at desired RPMs. . . None Voice None Set Engine Revs None None Three beeps None IntelliMute Set!None IntelliMute Set None In Program mode, go to IntelliMute Pro. Tone Two beeps Visual Display IntelliMute Pro On, then i blinks in the display IntelliMute Pro Off, then i is steady in the display IntelliMute Pro Off Voice IntelliMute Pro On One beep Setting IntelliMute RRMs IntelliMute Pro Off NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn Off. Tone One beep One beep 16 English Set Intel. . . PressSET. . . Intelli Mute Set! IntelliMute Pro On Intelli Mute Pro On NW ih Intelli Mute Pro Off NW ih Nothing Comes Close to a Cobra® 17 IntelliMute Not Set IntelliMute Off Visual Display IntelliMute not set Please try again IntelliMute Off Voice IntelliMute not set Please try again IntelliMute Off IntelliMu. . . Please tr. . . Intelli Mute Off Your Detector Settings N NW W SW S 8-Point Compass Your Detector Settings Set/City Button Compass Your detector includes an internal 8-point Compass that will continuously display your current direction of travel: N, NE, E, SE, S, SW, W or NW. Calibrating the Compass NE E SE Select/Dim Button Program/Mute Button To Calibrate the Compass Using Program Mode (See Page 7 For Instructions on Using Program Mode) In Program mode, go to Set Compass. Press and release the Set/City button to begin setting the compass. Tone None One (1) beep Visual Display Set Compass Voice None NOTE Before using it for the first time, you must calibrate the compass to provide accurate indications of direction. See page 7 for instructions on using the Program mode to select Set Compass. Calibration allows the compass electronics to measure and store information about the magnetic fields generated by your vehicle. The compass will remain accurately calibrated as long as your detector is mounted in the same place in your vehicle. If you change the location where the unit is mounted or move it to another vehicle, you must recalibrate the compass. The compass temporarily may not provide accurate readings if you are inside a building or enclosure, or are close to a large metal tractor/trailer, truck, or train. Once you are away from such a location, the compass will work correctly again. NOTE When the instructions direct you to drive in two circles, a large parking lot is the most convenient place to do so. It does not matter what direction your vehicle is pointing when you start the circles, which direction you go to make the circles, and it does not have to be exactly two circles. You do NOT have to make perfect circles. [. . . ] If this product should require factory service, please call Cobra first at 773-889-3087 BEFORE sending the product. This will ensure the fastest turnaround time on any repair. Notice Cobra will, without charge, repair or replace, at its option, defective 15 Band Radar/Laser Detectors, products or component parts upon delivery to the Cobra Factory Service Department, accompanied by proof of the date of first consumer purchase, such as a duplicated copy of a sales receipt. You must pay any initial shipping charges required to ship the product for warranty service, but the return charges will be at Cobra's expense, if the product is repaired or replaced under warranty. This warranty gives you specific rights, and you may also have other rights which vary from state to state. [. . . ]