User manual COBRA XRS 9745 QUICK START GUIDE

[. . . ] Introduction Intro Important Information and Customer Assistance Operation Customer Warranty Assistance Important Information Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio Secondary Icons transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety/Strobe Alert Use of this product is not intended to, and does not, ensure that motorists or passengers will not be involved in traffic accidents. [. . . ] Before IntelliMute Pro can be turned On, you must have turned On and Set the IntelliMute activation point. (See pages 14 through 16. ) Notice CAUTION When IntelliMute Pro is On, NO radar signals will be detected and NO alerts will be given at RPMs below the IntelliMute activation point. Warning Warranty In Program mode, go to Set IntelliMute. Notice Tone None Two beeps Visual Display Voice Installation Set IntelliMute None Secondary Icons Customer Assistance Press and release the Set/City button to begin setting IntelliMute RPMs. Press SET at desired RPMs. . . None Set Engine Revs None Notice Caution Main Icons Rev your engine to the level you wish to None set. Rev the engine slightly above idle and hold revs steady for two seconds. At the desired rev level, press and release the Set/City button. Three beeps None To Turn IntelliMute Pro On or Off Using Program Mode IntelliMute Set!None IntelliMute Set None (See Page 7 For Instructions on Using Program Mode) Intro Operation Customer Warranty Assistance Press and release either the Select/Dim button to proceed to the next user mode or the Program/Mute button to exit the Program mode. Secondary Icons In Program mode, go to IntelliMute Pro. Tone Two beeps Visual Display Voice IntelliMute Pro On, IntelliMute Pro On then i blinks in the display IntelliMute Pro Off, then i is steady in the display IntelliMute Pro Off Setting IntelliMute RRMs One beep Intelli Mute IntelliMute Pro On IntelliMute Pro Off Set Intel. . . PressSET. . . Notice NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn Off. IntelliMute Not Set Set! Intelli IntelliMute Off Intelli Mute Pro Off ih NW ih Nothing Comes Close to a Cobra® 17 Tone One beep One beep Visual Display IntelliMute not set Please try again IntelliMute Off Voice IntelliMu. . . Intelli Mute Please tr. . . Off Mute Pro On NW IntelliMute not set Please try again IntelliMute Off 16 English Main Icons Your Detector Intro Operation Settings Customer Assistance Warranty Your Detector Intro Operation Settings Customer Assistance Warranty Compass Intro N NW 8-Point Compass Your detector includes an internal Operation Customer Warranty Assistance 8-point Compass that will continuously display your current direction of travel: Secondary Icons N, NE, E, SE, S, SW, W or NW. NE Select/Dim Button Program/Mute Button Set/City Button W SW E SE Secondary Icons To Calibrate the Compass Using Program Mode (See Page 7 For Instructions on Using Program Mode) Secondary Icons Calibrating the Compass S In Program mode, go to Set Compass. Press and release the Set/City button to begin setting the compass. Notice Tone None One (1) beep Visual Display Voice Set Compass None Notice NOTE Notice Before using it for the first time, you must calibrate the compass to provide accurate indications of direction. See page 7 for instructions on using the Program mode to select Set Compass. Calibration allows the compass electronics to measure and store information about the magnetic fields generated by your vehicle. Drive in 2 Set Compass circles. . . Compass Set For two seconds followed by direction of travel (N, NE, E, SE, S, SW, W or NW) None None Main Icons Intro The compass will remain accurately calibrated as long as your detector is mounted in the same place in your vehicle. If you change the location where the unit Customer is mounted or move it to another vehicle, you must recalibrate the Warranty Operation Assistance compass. The compass temporarily may not provide accurate readings if you are inside a building or enclosure, or are close to a large metal tractor/trailer, truck, or train. Once you are away from such a location, the compass will work correctly again. NOTE When the instructions direct you to drive in two circles, a large parking lot is the most convenient place to do so. It does not matter what direction your vehicle is pointing when you start the circles, which direction you go to make the circles, and it does not have to be exactly two circles. You do NOT have to make perfect circles. You can drive in any pattern, as long as you make two complete turns. Four three-point turns, two small squares, or any two complete loops will work as well as two circles. It does not matter what size the circles are, if your speed is constant, or how fast you make the circles [but less than two minutes]. [. . . ] If this product should require factory service, please call Cobra first at 773-889-3087 BEFORE sending the product. This will ensure the fastest turnaround time on any repair. Notice · Secondary Icons Notice Cobra will, without charge, repair or replace, at its option, defective 15 Band Radar/Laser Detectors, products or component parts upon delivery to the Cobra Factory Service Department, accompanied by proof of the date of first consumer purchase, such as a duplicated copy of a sales receipt. You must pay any initial shipping charges required to ship the product for warranty service, but the return charges will be at Cobra's expense, if the product is repaired or replaced under warranty. This warranty gives you specific rights, and you may also have other rights which vary from state to state. [. . . ]