User manual CODUME R90 INSTALLATION

[. . . ] Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corporation. Energy Star is a trademark of the United States Environmental Protection Agency Other product names and brand names are registered trademarks or trademarks of their proprietors. 2 | CODUMEFAX 5650 MFP Option Kit Hardware Installation Overview ! Warning: The fax machine must be switched off and disconnected from the power supply before performing this procedure. 1. Switch off the fax machine and disconnect the power cable. Position the fax machine so that the rear is facing you and the fax machine extends slightly over the edge of your work surface. [. . . ] (i) When the Start Hardware Installation dialog appears, click Next. (j) When the Completing the Add/Remove Hardware Wizard dialog appears, click Finish. During copying, the Find Fax Port dialog appears and the fax port is found; then click OK. 10. When the Modem Installation dialog appears, click OK. 11. If the Location Information dialog appears, enter information about your current location and click OK. 12. When the Phone and Modem Options dialog appears, do the following: (a) Open the Modems tab and click Add. (b) Check Don't detect my modem; I will select it from a list. (c) Click Have Disk and when Install From Disk dialog appears, type D:\DRIVER\SETUP\DISK1\WIN2K (where D: is the drive letter of your CD-ROM drive) in Copy manufacturer's files from and click OK. (d) When the Install New Modem screen appears, select the appropriate device and click Next. (e) Check Selected ports, select the port displayed in Step 8, and click Next. (f) When Digital Signature Not Found appears, click Yes. (g) Click Finish and when the Modems Properties dialog appears, click OK. When the Modem Installation dialog appears, click OK. When the Install New Modem dialog appears, do the following: Note: If the Modems Properties dialog appears, click Add and the Install New Modem dialog pops up. (a) Check Don't detect my modem; I will Select it from a list. , and click Next. (b) Click Have Disk, and when Install From Disk dialog appears, type D:\DRIVER\SETUP\DISK1\WINNT40 (where D is the drive letter of your CD-ROM drive) in Copy manufacturer's files from and click OK. (c) When the Install New Modem screen appears, select the appropriate device and click Next. (d) Check Selected ports, then select the port displayed in Step 6 and click Next. (e) Click Finish, and when Modems Properties dialog appears, click Close. When the Install Complete screen appears, click OK. The setup of the driver is complete. Unimessage Setup After the installation of the CODUMEFAX driver is complete, the installation of the Unimessage Pro software should begin. If this does not happen or you are re-installing the Unimessage software: a) Insert the CODUMEFAX 5650 MFP Option Kit CD-ROM into your CD-ROM drive. b) After the setup program has automatically started, click Setup Unimessage Pro and follow the on-screen instructions. [. . . ] For best performance with all MFP functions, we recommend that you leave the status monitor on, except on network clients­see the following page. Setting up Clients on a Network (Unimessage Pro LAN) Unimessage Pro LAN can be installed on a client, so you can use an MFP connected to a host on the network. When you do this, do not install the scheduler--only one scheduler can run on a network at a time. Follow this procedure: Note: If you are using Windows NT 4. 0, make sure you have administrator access rights. 1. If the drive where Unimessage Pro is installed is not mapped on the client: a. [. . . ]