User manual COEF MASTER DISCO 96

[. . . ] The protection of the data is guaranteed by PASSWORD, for those operations which can cause the total or partial loss of data. By means of the RS232 port connecting to a personal computer, you can both upgrade the Master Disco 96 software and to save the settings and programs inserted. Take out the provided DC adapter and plug it into the relevant socket in the Master Disco 96 back panel (see fig. Pay attention that the cables and the connectors don't present short-circuits that could damage the DMX outputs of the Master Disco 96. [. . . ] Select the letter to be modified by means of S e T buttons and modify it by means of Y e Z (Down & UP digital channels section). "ChPrj: (value)": you set the channel number of the selected projector. you can control projectors up to 20 channels. Select the number of the channel by means of the S e T push-buttons. "ChMS96: (--- / value)": you set the number of the channel (slider / joystick) of the console controlling the X channel of the selected projector. Select the number of the channel by means of the S e T push-buttons. "Interpolation: (YES/ NO)": it means that each channel can be setted either Direct (quick change of the digital values from one scene to the other) or Intepolated (the values range between one scene and the other will be executed regulated by the CROSS time). In this way you will have the possibility to select the kind of AUDIO source that will pilot the automatic changing of the scene of the program in execution. Choose between the microphone input and the PIN RCA one by means of the S and T pushbuttons in the EDIT KEYPAD section (fig. In this way you will have the possibility to decide to enable or disable the RS232 port by means of the S and T push-buttons (fig. With the new software release, you can save and load the MasterDisco96 programs and configuration by means of the RS232 port and the Personal Computer. In this way you will have the possibility to enable or disable the BEEP pressing any push-button. Choose by means of the S and T buttons on the EDIT KEYPAD section (fig. 27, the display will ask you to set 4 numbers by means of the PROGRAMS section push-buttons (part. Automatically the system will ask you to repeat the inserted PASSWORD to verify its correctness; a double BEEP will confirm it's memorized. It's important: don't generate casual passwords because you could forget them, so you could hardly be able to unlock the system!This function will clear all the settings of the console and all the memorized programs. It's a function to be used only when strictly necessary and very carefully. Push ENTER in order to enter the stage of program preparation. Insert the personal PASSWORD in case you have saved your own one ( see chapter SET-UP ). the display will ask you to select one of the 16 programs (see fig. 45 part A) and after that it will show the following instructions (see fig. [. . . ] In this stage you also have the following functions available : a) scene changing by a given STAND time or by musical impulse (internal MIC or on LINE - see SETUP). B) temporary black-out of the program (shutter closing of all projectors) c) temporary STOP of the programs (projectors stopped with open shutter) d) manual use of some projectors even if they are used in the program Function a) It is possible to set a general time coefficient called KTS (STAND time) or KTC (CROSS time) to adjust the program execution by means of the push-buttons inserted in the TIMES section (part. The choice of the musical source must be setted in the SETUP stage. Press the push-button again to go back to the "time" function. [. . . ]