User manual COLEMAN 9995A700

[. . . ] Event Grill 9995A Series INSTRUCTIONS FOR USE © 2004 The Coleman Company, Inc. www. coleman. com IMPORTANT Read this manual carefully before assembling, using or servicing this grill. If you have questions about assembly, operation, servicing or repair of this grill, please call Coleman at 1-800-835-3278 or TDD: 316-832-8707. The handling, storage and transportation of gas cylinders must be in accordance with ANSI/NFPA 58, Storage and Handling of Liquified Gases, or CSA B149. 1, Natural Gas and Propane Installation Code. The owner shall post in a prominent location instructions to be followed in the event the user smells gas. This informatin shall be obtained by consulting the local gas supplier. · 9-volt Battery included · 20# L. P. [. . . ] Push in and turn on control knobs to release pressure in hose, then return the control knobs to OFF. Wash off soapy solutions with cold water and towel dry. Stop a leak by tightening the loose joint, or by replacing the faulty part with a replacement part recommended by Coleman. DO NOT attempt to repair the cylinder valve if it should become damaged; the cylinder MUST be replaced. If you are unable to stop a leak, shut off the gas supply at the cylinder valve. DO NOT use grill until the leak is corrected. Perform a leak test each time the gas supply cylinder is connected to the regulator. Leak test anytime a part of the gas system is replaced. Perform a leak test at least once each year whether the L. P. gas supply cylinder has been disconnected or not. Have a dealer check the cylinder for deterioration after 12 years, according to DOT regulations. Immediately replace cylinder if any deterioration is found Lighting the Grill WARNING THE FOLLOWING RULES MUST ALWAYS BE FOLLOWED IN THIS ORDER : 1. Check that the Burner Control Knobs are turned to "OFF. " 2. gas cylinder, turn the top cylinder valve knob counterclockwise to open. DO NOT stand with head or arms over grill. WARNING This procedure MUST be performed OUTDOORS only!Read and follow directions on the cylinder and fuel hose safety tags. CAUTION In the connection process, the grill side of the connection will seal on the back-check in the valve, resulting in a slight resistance. The connection requires about one-half to three-quarters additional turn to complete the connection. DO NOT use tools. CAUTION Inspect the gas supply hoses before each use. If there are cuts, damage, excessive abrasion or wear, replace the hoses prior to operating the appliance. During assembly of grill and when attaching or replacing the L. gas cylinder, insure that all gas supply hoses are free of kinks and/or damage and are at least 3" away from hot surfaces such as the grill housing. Use only hose replacements specified in the parts list. Step 1 Make sure Burner Valves are in OFF position. Start-Up Check List WARNING Failure to follow these safety steps before using grill each time could result in a fire that could be hazardous to you, your appliance or property. [. . . ] Replacement will be made with a new or remanufactured product or component. If the product is no longer available, replacement may be made with a similar product of equal or greater value. This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Proof of purchase is required to obtain warranty performance. [. . . ]