User manual COMPAQ 49G

[. . . ] Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. Edition 1, 8/2005 Trademark Credits Microsoft®, MS-DOS®, Windows®, are U. S. registered trademarks of Microsoft Corporation. [. . . ] Check the indicator lights on the server module: The power/status light (2) on top of the server module should light solid green within 15 seconds to show proper startup. Then it may flicker irregularly to show network communication. One of the LAN connector lights (3) should turn on to show the network connection speed. The USB/projector light (1) on top of the server module should light solid green to show a good USB connection. If any of these does not occur, see "Indicator Lights" on page 14. Installing the HP Jetdirect Module 7 Mounting the Module (Optional) You can mount the server module on the projector or on any nearby smooth, clean surface. The attachment strips separate to allow you to remove the module temporarily. Decide where to mount the server module on the projector or other surface: Make sure the mounting surface is flat, smooth, and clean. Do not block any vents, controls, or access panels on the projector. Make sure the cables from the module do not interfere with controls or access panels on the projector. 2. Peel the backing paper off one side of an attachment strip. Note Do not separate the two halves of the strip. 3. Attach the strip along the top or bottom edge of the label on the bottom of the server module. You can download this software for free at www. hp. com/go/webjetadmin. Web Jetadmin supports the management of Jetdirect-compatible HP projectors. Support for projectors requires HP Web Jetadmin version 7. 8 or greater, along with the HP Web Jetadmin application plug-in for digital projectors. We recommend using the latest version, which may provide enhanced functionality. Web Jetadmin provides access to all the functions of the embedded Web server -- and it supports many operations on groups of projectors. For complete information, go to www. hp. com/go/webjetadmin. Managing HP Projectors 12 4 Fixing Problems Troubleshooting If you have trouble with your server module or network connection, check the information in this chapter. Note If you have trouble with projector operation, see the projector user manual. 1. Make sure the projector is connected to power and is operating properly. See the projector user manual if the projector has any problems. Make sure the server module is connected to power, to a local-area network (LAN), and to the projector. Check the indicator lights on top of the server module: If the power/status light is flickering irregularly and the USB/projector light is solid green, the setup is good. [. . . ] Connect the module to a different LAN outlet. See the Administrator's Guide. On steady (green) Normal: USB is ready. Fixing Problems 14 USB/Projector Light Off Module is starting up (up to 15 seconds after applying power), or a USB problem is detected. Make sure a USB cable connects to a projector, and the projector is connected to power. Try a different USB cable. If the condition persists, the module or projector is faulty. If possible, repeat with a different module or projector. On steady (green) Blinking (green) Normal: USB is ready. [. . . ]