User manual COMPAQ CQ2100 GETTING STARTED

[. . . ] The only warranties for Hewlett-Packard products and services are set forth in the express statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. hP shall not be liable for technical or editorial errors or omissions contained herein. HP assumes no responsibility for the use or reliability of its software on equipment that is not furnished by HP. [. . . ] ) Reconnect the power plug to the back of the monitor and to the wall outlet. press the On button on the front of the monitor. Press the space bar on the keyboard or move the mouse to make the screen display visible again. Press the Sleep button (select models only), or the Esc key on the keyboard, to resume from Sleep mode. If any of the pins are bent, replace the monitor connector cable. Possible solution (In addition to the information listed here, also refer to the documentation that came with your monitor. ) If you use an HDMI connector on the graphics card (select models only) to connect your display (monitor) to the computer, because the default setting is the DVI connector, you hear no sound from your display. You should connect analog speakers to the computer Audio Line Out connector if you want to hear sound during the initial setup of the computer. To change settings and hear sound from your HDMI-connected display: NOTE: If you ever need to recover the computer operating system by using the Recovery Manager, you must repeat this procedure to activate sound for the HDMI connector. 1 Right-click the white Microsoft Volume icon (white speaker) on the taskbar, and then click Playback Devices. If you used Digital Output Device (HDMI), click OK to close the window. This completes the steps to activate HDMI sound for this option. If you used Realtek HDMI Output, continue with step 5. 0 KHz check box, and ensure that there is no check in the Dolby Digital check box and all other check boxes. NOTE: For most TVs to play back audio, the sample rate must be 48. 8 Images on the screen are too large or too small, or the images are fuzzy. This completes the steps to activate HDMI sound for this option. Adjust the monitor resolution setting in Windows Vista: 1 2 3 Right-click an empty area on the desktop, and then click Personalize. Adjust Resolution as necessary, and then click Apply. Mouse (with cable) does not work or is not detected. cursor does not respond to mouse movement. Possible solution Turn off the computer by using the mouse, unplug and reconnect the keyboard to the back of your computer, and then turn on your computer. [. . . ] press the On button to turn on the computer. A window may open, prompting you to choose between running system recovery from the discs or from your hard drive. Choose to run from the recovery discs, and then click Next. in the Welcome to the Recovery Manager window , click the Advanced Options button. [. . . ]