User manual COMPAQ HP DF810

[. . . ] Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] However, content from only one memory source can be selected for playback. To select the desired picture source, there are many methods to get to the memory source selection menu. This will display the memory source screen as illustrated below. Note: The screen may differ depending on type and number of external memory devices that are inserted. This will bring up the MAIN MENU for the memory source just selected. Slideshow modes Slideshow mode will begin automatically a few seconds after the frame is powered on or when an external memory card/USB Flash drive is inserted. There are two slideshow modes, one with background music and the other without. Review the Initial Setup and Setup Menu sections of this document for details on how to change desired settings. "Browse mode" will be displayed on the lower right of the screen for a few seconds. This allows forward and previous picture viewing. To view pictures in a thumbnail mode, press TWiCE when in slideshow or OnCE when in browse mode as illustrated below. Note: if a picture is rotated while in slideshow mode, the frame will automatically enter into photo browse mode. Each press of this button will rotate the picture by 90 degrees to the right. Each press of this button will increase the zoom by 1X until 5X. At 5X, press this button OnCE to return to the original view. Note: if a picture is zoomed while in slideshow mode, the frame will automatically enter into photo browse mode. Once in zoom mode, use the arrow buttons to position the picture for desired viewing. Copying pictures onto frame internal memory From an external memory device: With the picture frame powered off, insert an external memory device with the preferred pictures into the appropriate connector. Turn the picture frame power ON and a slideshow from the external memory will automatically begin in a few seconds. Again to copy the desired display internal Memory. press picture onto the frame's internal memory. A Finished text box will be displayed indicating the picture is now in the internal memory as illustrated below. [. . . ] Use the & buttons to move between the calendar, clock, audible sound type, and On/OFF values. Press when desired settings are selected. - Internal Memory will display pictures from the frame's internal memory in a slideshow mode while in Calendar mode as shown below: Note: OnlY pictures from the internal memory will be displayed. The transition timing will be about 60 seconds and CAnnOT be changed. [. . . ]