User manual COMPAQ MINI 1000 NETBOOK MAINTENANCE AND SERVICE GUIDE

[. . . ] HP Mini 1000 Netbook Compaq Mini 700 Netbook Maintenance and Service Guide © Copyright 2008 Hewlett-Packard Development Company, L. P. Bluetooth is a trademark owned by its proprietor and used by Hewlett-Packard Company under license. Intel and Atom are trademarks of Intel Corporation in the U. S. registered trademarks of Microsoft Corporation. [. . . ] Release the ZIF connector (1) to which the SIM card cable is attached. The end of the cable lies across the top of the solid-state drive. Disconnect the SIM card cable (2), and then detach the tape from the top of the solid-state drive. 3. 5. Release the LIF connector (1) to which the solid-state drive cable is attached. Disconnect the solid-state drive cable (2). Remove the two Phillips PM2. 0×4. 5 screws (3) that secure the drive bracket to the device. Component replacement procedures 43 6. Remove the drive bracket (4) from the drive bay. 7. 8. Remove the three Phillips PM2. 0×3. 0 screws (1) that secure the solid-state drive to the bracket. Remove the solid-state drive (2) from the bracket. Reverse this procedure to install the solid-state drive. 44 Chapter 4 Removal and replacement procedures Top cover Description Top cover (includes TouchPad) Spare part number 504612-001 Before removing the top cover, follow these steps: 1. If you are unsure whether the device is off or in Hibernation, turn the device on, and then shut it down through the operating system. Disconnect all external devices connected to the device. Disconnect the power from the device by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the device. Remove the battery (see Battery on page 37). Remove the keyboard (see Keyboard on page 40). Remove the hard drive or solid-state drive (see Mass storage devices on page 42). Turn the device upside down, with the front toward you. Use a thin, flat tool to remove the four screw covers (1). There are three different variations of the covers, each of which is shaped like a rounded square: 3. The two front covers are short in height and are notched to prevent incorrect insertion. The right rear cover is taller in height and is notched. The left rear cover is taller in height and is not notched. Remove the four Phillips PM2. 5×7. 0 screws (2) that secure the top cover to the base enclosure. 4. Turn the device right-side up, with the front toward you. Component replacement procedures 45 5. 6. Open the device as far as possible. Remove the Phillips PM2. 0×4. 5 screw (1) and the Phillips PM2. 5×5. 0 screw (2) that secure the top cover to the base enclosure. 7. Lift the rear edge of the top cover (1) and swing it up. [. . . ] For disposal or recycling information, contact your local authorities, or see the Electronic Industries Alliance (EIA) Web site at http://www. eiae. org. This section provides disassembly instructions for the display assembly. The display assembly must be disassembled to gain access to the backlight (1) and the liquid crystal display (LCD) panel (2). NOTE: The procedures provided in this appendix are general disassembly instructions. Specific details, such as screw sizes, quantities, and locations, and component shapes and sizes, can vary from one computer model to another. Battery 103 Perform the following steps to disassemble the display assembly: 1. [. . . ]