User manual COMPAQ PHOTOSMART PRO B8800

[. . . ] The information contained in this document is subject to change without notice. Reproduction, adaptation, or translation of this material is prohibited without prior written permission of Hewlett-Packard, except as allowed under copyright laws. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. [. . . ] If this is the first time you are installing the ink cartridges and printheads, see the Quick Start Guide for information on the initial set up of ink cartridges and printheads. For best results, keep the outside of the printer clean. If you notice any ink residue on the outside of the printer, be sure to clean it off using the following steps. NOTE: Never clean the inside of the printer. Wipe the outside of the printer with a soft cloth that has been lightly moistened with water. Be sure to wipe away any ink residue that has accumulated on the output tray. CAUTION: Do not use any type of cleaning solution. Do not clean inside the printer If you notice white lines or single-color streaks on the photos you print, the printheads might need to be cleaned. TIP: You can also open the printer Toolbox from the HP Solution Center on your computer. Following the directions on the computer screen, load paper so the printer can print a test page after cleaning the printheads. Use Letter or A4-sized plain paper to conserve photo paper. TIP: You can also open the HP Printer Utility from the HP Device Manager in the Dock. If you still notice white streaks or missing colors on the test page after cleaning the printheads automatically, you might need to clean the printhead nozzles manually. NOTE: Do not clean the printheads more often than necessary, since the cleaning uses ink. The first time you install printheads in the printer or if you replace a faulty printhead, the printer performs a printer alignment and color calibration automatically. However, if colors in the photos you print are misaligned, or if the alignment page does not print correctly when you install a new printhead, use the following procedure to re-align the printheads. For consistent color reproduction from print to print, be sure to calibrate the printer color periodically. Before aligning and calibrating the printer, check that you are using the correct paper. Use Letter or A4-sized HP Advanced Photo paper - Glossy. If you use a different type of paper, the results may not be accurate. Load Letter or A4-sized HP Advanced Photo paper - Glossy in the main tray. TIP: You can also open the printer Toolbox from the HP Solution Center on your computer. [. . . ] See Quick Start Guide specifications 39 printer driver, changing settings 14 printer software, updating 26 printheads, cleaning 24 printing black and white 16 changing settings 14 from a computer 6 grayscale 16 test page 26 troubleshooting problems 31 See Error states and indicator lights behavior Digital Fine Art media. Technical support 36 test page 26 toolbox 21 trays, paper 3 Troubleshooting 29 troubleshooting error messages 33 flashing lights 30 HP support 36 printer hardware problems 30 printing problems 31 software installation 29 Error states and indicator lights table 37 See Paper trays Frequently asked questions 29 front paper slot. Bac support spécial (fermé) : abaissez ce bac pour insérer une feuille d'un support épais, tel qu'une carte ou un canevas. Bac support spécial (ouvert) : insérez dans ce bac une feuille d'un support épais, tel qu'une carte. [. . . ]