User manual COMPX C1802

[. . . ] Clean the terminals before charging the battery pack if any foreign substances are found on the terminals. The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. CAUTION: To protect the motor or battery, be sure to note the following when carrying out this operation. € If the motor or battery becomes hot, the protection function will be activated and the motor or battery will stop operating. [. . . ] (C1802) - 13 - • If both the battery low warning lamp and LED light flash, reduce the force with which you are pushing on the driver or, if using a drill driver, adjust the speed switch to a lower setting. (C1802) Dust Collection Cup (EY9X005E) (Available as an optional accessory) * Drill bits of which diameter is 20 mm above cannot be inserted through dust collection cup. * Do not use the tool for cutting other than concrete, mortar and other ceramic materials. If used for cutting metal materials, the dust collection cup may be damaged by the metal chip heat. * Do not use this tool with any drill bit which is shorter than 130 mm in length. Pass the drill bit through A and fix the cup at B by matching with the shape of the cluch handle. B Installing the Shoulder Strap CAUTION: • Install the shoulder strap firmly to the main unit of the tool and check the length of the strap before use. € Check the condition of the strap and do not use if it is cut or torn etc. There is a risk of injury or damage if used while improperly installed. € Please wear the shoulder strap securely on the shoulder. There is a risk of injury or damage if it is accidentally dropped. • The ambient temperature range is between 0°C (32°F) and 40°C (104°F). If the battery pack is used when the battery temperature is below 0°C (32°F), the tool may fail to function properly. € Use the charger at temperatures between 0°C and 40°C, and charge the battery at a temperature similar to that of the battery itself. (There should be no more than a 15°C difference between the temperatures of the battery and the charging location. ) • When charging a cool battery pack (below 0°C (32°F)) in a warm place, leave the battery pack at the place and wait for more than one hour to warm up the battery to the level of the ambient temperature. € Cool down the charger when charging more than two battery packs consecutively. € Do not insert your fingers into contact hole, when holding charger or any other occasions. - 15 - Li-ion Battery Pack CAUTION: To prevent the risk of fire or damage to the battery charger. € Do not use power source from an engine generator. € Do not cover vent holes on the charger and the battery pack. NOTE: Your battery pack is not fully charged at the time of purchase. [. . . ] A replacement fuse cover can be purchased from your local Panasonic Dealer. If a new plug is to be fitted please observe the wiring code as shown below. if in any doubt please consult a qualified electrician. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. [. . . ]