User manual COMPX C1974

[. . . ] Clean the terminals before charging the battery pack if any foreign substances are found on the terminals. The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. CAUTION: To protect the motor or battery, be sure to note the following when carrying out this operation. € If the motor or battery becomes hot, the protection function will be activated and the motor or battery will stop operating. [. . . ] -10- Switch lock A switch lock prevents the motor from starting if the switch is pulled inadvertently. € To disengage the lock, press the off-lock switch. (The switch can be pressed on either side of the tool. ) • While you are on the switch, the tool will continue to operate even if you remove your fingers from the off-lock switch. € Do not touch the jigsaw blade immediately after cutting. If this is not observed, burns may occur. Holding the tool and pushing on it Hold the tool securely with both hands. There is no need to exert excessive force on the tool while operating it. Exercise caution as applying excessive force to the tool in a prying or pushing motion may damage the tool. When cutting in a small arc, a lower feed speed will result. Attempting to move the saw too quickly may damage the reciprocating saw blade. If the battery pack is used when the battery temperature is below 0°C (32°F), the tool may fail to function properly. € When charging a cool battery pack (below 0°C (32°F)) in a warm place, leave the battery pack at the place and wait for more than one hour to warm up the battery to the level of the ambient temperature. battery Pack Life The rechargeable batteries have a limited life. If the operation time becomes extremely short after recharging, replace the battery pack with a new one. Battery Recycling ATTENTION: For environmental protection and recycling of materials, be sure that it is disposed of at an officially assigned location, if there is one in your country. [Battery Pack] For Appropriate Use of Battery pack Li-ion Battery pack • For optimum battery life, store the Li-ion battery pack following use without charging it. € When charging the battery pack, confirm that the terminals on the battery charger are free of foreign substances such as dust and water etc. Clean the terminals before charging the battery pack if any foreign substances are found on the terminals. The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. € When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause sparks, burns or a fire. [. . . ] NOTE: For the dealer name and address, please see the included warranty card. ELECTRICAL PLUG INFORMATION FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5 amp and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. [. . . ]