User manual COMPX C2018

[. . . ] Clean the terminals before charging the battery pack if any foreign substances are found on the terminals. The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. CAUTION: To protect the motor or battery, be sure to note the following when carrying out this operation. € f the motor or battery becomes hot, the protection function will be activated and the motor or battery will stop I operating. [. . . ] € If the tool is operated continuously under high-load conditions or if it is used in hot-temperature conditions (such as during summer), the overheating protection feature may activate frequently. € If the tool is used in cold-temperature conditions (such as during winter) or if it is frequently stopped during use, the overheating protection feature may not activate. € The performance of the EY9L42 deteriorates significantly at and below 10°C due to work conditions and other factors. • The ambient temperature range is between 0°C (32°F) and 40°C (104°F). If the battery pack is used when the battery temperature is below 0°C (32°F), the tool may fail to function properly. € Use the charger at temperatures between 0°C and 40°C, and charge the battery at a temperature similar to that of the battery itself. (There should be no Excessive (complete) discharging of lithium ion batteries shortens their service life dramatically. The driver includes a battery protection feature designed to prevent excessive discharging of the battery pack. € The battery protection feature activates immediately before the battery loses its charge, causing the battery low warning lamp to flash. € If you notice the battery low warning lamp flashing, charge the battery pack immediately. € If it is started with too little battery power remaining, the tool may stop operating without the battery low warning lamp flashing first. € Do not use power source from an engine generator. € Do not cover vent holes on the charger and the battery pack. battery Pack Life The rechargeable batteries have a limited life. If the operation time becomes extremely short after recharging, replace the battery pack with a new one. Li-ion Battery Pack NOTE: Battery Recycling ATTENTION: For environmental protection and recycling of materials, be sure that it is disposed of at an officially assigned location, if there is one in your country. Your battery pack is not fully charged at the time of purchase. Be sure to charge the battery before use. Insert the battery pack firmly into the charger. 1 Line up the alignment marks and place the battery onto the dock on the charger. 2 Slide forward in the direction of the arrow. During charging, the charging lamp will be lit. [. . . ] - 79 - Kontroludløser for variabel hastighed For at bestemme centrum af et hul trykker du kun let på udløseren for at starte borestykkets rotation på langsom hastighed. - 80 - (3) Advarselslampe for overophedning (4) Advarselslampe for lav batterieffekt Fra Off (normal (normal anvendelse) operation) Lyser: Blinker: Illuminated: Flashing: Overophedning Overophedning Overheat Overheat (motor) (batteri) (motor) (battery) Betyder, at anvendelsen er Indicates operationgrund af blevet stoppet på has been halted due to motor overophedning af motoren eller batteriet. € Hvis der fra starten af var for lidt strøm tilbage, kan værktøjet stoppe driften uden at advarselslampen for lavt batteri først blinker. dette indikerer , at der er for lidt strøm tilbage til at bruge værktøjet , og batteriet skal oplades før yderligere brug. [. . . ]