User manual COMPX C2174-1DC-KD

[. . . ] €  hen charging the battery pack, confirm that the terminals on the battery charger are free of foreign W substances such as dust and water etc. Clean the terminals before charging the battery pack if any foreign substances are found on the terminals. The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. CAUTION: To protect the motor or battery, be sure to note the following when carrying out this operation. [. . . ] this may result in an accident or injury. When the main unit is held by the belt hook, avoid jumping or running with it. Doing so may cause the hook to slip and the main unit may fall. this may result in an accident or injury. When the belt hook is not used, be sure to return it to the storing position. this may result in an accident or injury. When the unit is hooked onto the waist belt by the belt hook, do not attach driver bits to the unit. EY7443 (1) LED light Before the use of LED light, always pull the power switch once. The light illuminates with very low current, and it does not adversely affect the performance of the tool during use or its battery capacity. CAUTION: ●● ●● ●● The built-in LED light is designed to illuminate the small work area temporarily. Do not use it as a substitute for a regular flashlight, since it does not have enough brightness. If it is started with too little battery power remaining, the tool may stop operating without the battery low warning lamp flashing first. This indicates that there is too little battery power remaining to use the tool, and the battery pack should be charged before further use. If the tool is subject to a sudden load during use that causes the motor to lock up, the overdischarge prevention sensor may be triggered, and the battery low warning lamp may flash. The lamp will stop flashing once you address the cause of the motor’s locking up and cycle the trigger. ●● ●● ●● ●● EY7441/EY7940/C2174-1DC-KD - 14 - EY7441_EY7940_EY7443_C2174-1DC-KD_Book. Indb 14 2012-12-11 9:21:11 EY7443 ●● ●● ●● ●● ●● ●● The battery protection feature may activate when a high load is abruptly placed on the motor, even if ample battery charge remains. In this case, both the battery low warning lamp and LED light will flash (EY7443, C2174-1DC-KD). If both the battery low warning lamp and LED light flash, reduce the force with which you are pushing on the driver or, if using a drill driver, adjust the speed switch to a lower setting (EY7443, C2174-1DC-KD). If the tool does not switch between HIGH and LOW speed operation in AUTO mode, the motor will stop and the battery low warning lamp and the overheat warning lamp will alternately flash. If both lamps alternately flash, depress the trigger again. (EY7443) When operating the battery pack, make sure the work place is well ventilated. [. . . ] IMPORTANT: As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED. Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter E or the Earth Symbol . [. . . ]