User manual COMPX C8052

[. . . ] It also deactivates viruses and bacteria on the filter to keep inside of the unit clean. 2 Quick guide Table of contents Inserting the batteries 1 3 2 1 Pull out the back cover of remote control 2 Insert AAA or R03 batteries (can be used ~ 1 year) 3 Close the cover 2 TIMER ON 1 2 SET 3 Safety precautions . 62 English 3 Clock setting 1 Press CLOCK 2 Set the time 3 Confirm OFF CANCEL AC RC 1 SET CHECK CLOCK Accessories • Remote control • AAA or R03 batteries × 2 • Remote control holder • Screws for remote control holder × 2 RESET Basic operation 1 Select the desired mode AUTO HEAT AUTO HEAT COOL DRY MILD DRY FAN SPEED AIR SWING DRY COOL 2 Start/stop the operation 2 3 1 ECONAVI OFF/ON AUTO COMFORT POWER MODE MILD DRY COOLING NANOE-G TEMP • Please note that the OFF indication is on to start. 3 Select the desired temperature • Selection range: 16 °C ~ 30 °C. [. . . ] Do not place a vase or water container on the unit. Water may enter the unit and degrade the insulation. Do not open window or door for long time during COOL/DRY mode operation. Prevent water leakage by ensuring drainage pipe is: - Connected properly, - Kept clear of gutters and containers, or - Not immersed in water After a long period of use or use with any combustible equipment, aerate the room regularly. After a long period of use, make sure the installation rack does not deteriorate to prevent the unit from falling down. English Safety precautions Remote control Do not use rechargeable (Ni-Cd) batteries. To prevent malfunction or damage of the remote control: • Remove the batteries if the unit is not going to be used for a long period of time. € New batteries of the same type must be inserted following the polarity stated. CAUTION Indoor unit and outdoor unit Do not wash the indoor unit with water, benzine, thinner or scouring powder to avoid damage or corrosion at the unit. Power supply Do not disconnect the plug by pulling the cord to prevent electric shock. 5 How to use POWER TIMER AUTO COMFORT NANOE-G POWERFUL QUIET (Green) ECONAVI (Orange) (Green) (Blue) (Orange) (Orange) (Green) Indicator To optimise energy saving MODE To select operation mode - For your convenience - To enjoy warm air - To enjoy cool air - To dehumidify the environment Remote control display Human activity sensor Sunlight sensor and remote control receiver AUTO HEAT COOL DRY AUTO HEAT COOL DRY MILD DRY FAN SPEED AIR SWING MILD DRY COOLING To improve humidity and moisture level ECONAVI OFF/ON AUTO COMFORT • This operation reduces air dryness and provides you with a comfortable living environment during COOL mode only. € In HEAT mode, if AUTO is set, the horizontal louver is fixed at the predetermined position. The vertical louver swings left/right after the temperature rises. Note ECONAVI POWERFUL/ QUIET AUTO COMFORT NANOE-G ECONAVI POWERFUL/ QUIET AUTO COMFORT , , , • Can be activated in all modes and can be cancelled by pressing the respective button again. How to use To deactivate viruses/bacteria on the filter 1 Select ON or OFF timer • Each time pressed: Example: OFF at 22:00 English • nanoe-G starts automatically when the unit is turned on with OFF/ON . € Unit selects operation mode every 10 minutes according to setting temperature and room temperature. The POWER indicator blinks during this operation. COOL: Use curtains to screen off sunlight and outdoor heat to reduce power consumption during COOL mode. DRY : Unit operates at low fan speed to give a gentle cooling operation. Nanoe-G in-filter deactivation Depending on the unit’s accumulated operation time, nanoe-G in-filter deactivation may activate only once a day after the unit turned off. To remove the moisture left in the internal parts, the fan will operate for 30 minutes with louver opened slightly. This process only applicable when the unit is operated in COOL/DRY mode before turned off. [. . . ] € Certain fluorescent lights may interfere with signal transmitter. NON SERVICEABLE CRITERIAS TURN OFF POWER SUPPLY AND UNPLUG then please consult authorised dealer under the following conditions: • Abnormal noise during operation. € Water/foreign particles have entered the remote control. The unit stops and the TIMER indicator blinks. [. . . ]