User manual COMPX C8178

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. As the main plug is used to disconnect the unit from the mains, connect the unit to an easily accessible AC outlet. Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Notice for customers: the following information is only applicable to equipment sold in countries applying EU directives The manufacturer of this product is Sony Corporation, 1-7-1 Konan, Minato-ku, Tokyo, 108-0075 Japan. [. . . ] Remove the old battery and install a new one. The CD, radio, iPod or buzzer alarm does not sound at the preset alarm time.  Check that “ALARM A” or “ALARM B” is properly displayed. Approx. 145 × 156. 8 × 115. 8 mm (w/h/d) (5 3/4 × 6 1/4 × 4 5/8 inches) not including projecting parts and controls Mass Approx. 1. 3 kg (2 lb 13 oz) including power supply unit Supplied accessories Remote commander (1) AM loop aerial (1) Audio connecting cable (1) Universal Dock Adapter for iPhone (1) Universal Dock Adapter for iPhone 3GS & iPhone 3G (1) Universal Dock Adapter for iPhone 4S & iPhone 4 (1) Design and specifications are subject to change without notice. Knowing when to replace the battery When the battery becomes weak, “” appears in the display. If a power interruption occurs while the battery is weak, the current time and alarm will be erased. Replace the battery with a Sony CR2032 lithium battery. Use of another battery may cause a fire or explosion. Note If “0:00” flashes in the display when the unit is connected to AC outlet for the first time, the battery may be weak. In this case, consult your Sony dealer. 4 Make sure the AM loop aerial is Adjusting the AM loop aerial connected firmly by pulling softly. Find a place and an orientation that provide good reception.  Do not place the AM loop aerial near the unit or other AV equipment, as noise may result. The setting will be displayed for 4 seconds. To change an alarm setting To cancel Automatic DST/Summer Time adjustment during the daylight saving time (summer time) period The CD, iPod & iPhone  and VOLUME + buttons have a tactile dot. The Automatic DST/Summer Time adjustment can be cancelled. Press and hold CLOCK and BRIGHTNESS/ TIME ZONE at the same time while the clock is displayed. “Auto  OFF” appears in the display to show that Automatic DST/Summer Time adjustment has been cancelled. Notes  The change timing of Automatic DST/Summer Time adjustment employed by the unit (see above) is subjected to variation by circumstances and the law in each country/ region. In such a case, cancel the Automatic DST/Summer Time adjustment and set the DST display manually as necessary. Customers living in a country/region that does not use the daylight saving time (summer time) must cancel Automatic DST/Summer Time adjustment before using the unit.  To activate Automatic DST/Summer Time adjustment again, press and hold CLOCK and BRIGHTNESS/ TIME ZONE at the same time. “Auto → ON” appears in the display to show that Automatic DST/Summer Time adjustment has been activated. The display returns to the clock. All the tracks are played once.  Close the lid “REP 1” (single repeat) A single track is played repeatedly.  “REP” (all repeat) All the tracks are played repeatedly. [. . . ] Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. Please be aware that among those discs, there are some that do not conform to the CD standard and may not be playable by this product. To handle compact discs Correct Handle the disc by its edge. Presetting a station 1 Follow steps 1 and 2 in “Manual tuning” to tune the frequency you wish to preset. 2 Hold down MEMORY/DISPLAY for at least 2 seconds. [. . . ]