User manual COMPX C8706

[. . . ] How to replace the fuse The location of the fuse differ according to the type of AC mains plug (figures A and B). Confirm the AC mains plug fitted and follow the instructions below. Illustrations may differ from actual AC mains plug. Figure A Figure B Fuse cover Specifications Amplifier section RMS output power stereo mode Front Ch (both ch driven) 5 W per channel (6 ), 1 kHz, 10% THD Total RMS stereo mode power 10 W Overview of controls Front view SLEEP DIMMER Operating Instructions Compact Stereo System Model No. A 5-ampere fuse is fitted in this plug. [. . . ] “FLAT” : Cancels the sound effect. “BASS -4” to “BASS +4”. “TREBLE-4” to “TREBLE+4”. “ON D. BASS” or “OFF D. BASS”. “ON SURROUND” or “OFF SURROUND”. 1 2 Press [PLAY MENU] to select “PLAYMODE” or “REPEAT”. Press [R, T] and then press [OK] to select the desired mode. Dock adapter (not supplied) Connector Note: • Make sure to remove the iPod/iPhone from its case. • Make sure to align your iPod/iPhone with the connector when inserting. • If a dock adapter is not available, insert and remove the iPod/iPhone with care. Note: Do not use a USB extension cable. The system cannot recognise USB device connected through a cable. Note: • Depending on the model, it may be necessary to remove the iPod/iPhone and select the album, artist, etc. • Operation results may vary depending on the iPod/iPhone models. • Read the User Guide of the iPod/iPhone for the operating instructions. 1 2 3 Press [SETUP] to select “CLOCK”. • The setting returns to default when you open the sliding door. This function switches off the system (except in radio source) if you do not use the system for approximately 30 minutes. 1 2 Press [SETUP] to select “AUTO OFF”. Press [R, T] to select “ON” or “OFF” and then press [OK]. Note: Keep fingers away from the sliding door when it is closing. Radio 30 FM stations can be preset. DAB/DAB+ Note: A station previously stored is overwritten when another station is stored in the same preset number. This system support DAB in “BAND III” bands. Troubleshooting To preset the station Preparation Connect the DAB antenna (Z “Getting started”). Press [RADIO] to select “FM”. Preparation Connect the DAB antenna (Z “Getting started”). Press [RADIO] to select “DAB/DAB+”. If you select “DAB/DAB+” for the first time, the system will start the “DAB AUTO SCAN” procedure. Selecting a preset station 4 5 6 Press [OK]. Do steps 3 through 6 again to preset more stations. DAB settings 1 2 Press [PLAY MENU] to select an option. Press [R, T] to select the desired setting and then press [OK]. Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the solutions indicated do not solve the problem, consult your dealer for instructions. USB The USB device or the contents in it cannot be read. • The format of the USB device or the contents in it is/are not compatible with the system. • USB devices with storage capacity of more than 32 GB cannot work in some conditions. • Large content size or large memory USB device takes longer time to read. The elapsed time shown is different from the actual play time. [. . . ] “ADJUST TIMER” • Play timer is not set. “DATA” • Data broadcast being received over the DAB broadcast signal cannot be used on this system. “ERROR” • An incorrect operation was done. “F61” • There is a power supply problem. 1 2 3 Press [PLAY MENU] to select “TUNEMODE”. [. . . ]