User manual CONCEPTRONIC C54BRS4A

[. . . ] CONCEPTRONIC C54BRS4A 802. 11g Wireless Broadband Router User Manual Conceptronic C54BRS4A User Manual About This Manual This manual provides descriptions of the Conceptronic C54BRS4A 802. 11g Wireless Broadband Router, its hardware and software features, and how to set up and use the device on your small office or home network. Before You Start Please read and make sure you understand all the prerequisites for proper installation of your new Wireless Broadband Router. Have all the necessary information and equipment on hand before beginning the installation. A packing list is included at the end of this section. Installation Overview The procedure to install the Wireless Broadband Router can be described in general terms in the following steps: 1. Gather information and equipment needed to install the device. [. . . ] Typically the globally IP settings (i. e. IP address for the WAN interface) for a PPPoE connection will use Dynamic IP assignment from the ISP. Some accounts may be assigned a specific global IP address. Choose the desired Connect mode select setting. Select from: Always on, Manual, or Connect on demand. Most users will want to choose the default connection setting, Always on. When you are satisfied that all the WAN settings are configured correctly, click on the Apply button. The new settings must be saved and the Router must be restarted for the settings to go into effect. To save and reboot the Router, click on the Tools directory tab and then click the System button. In the System Settings window, click the Save button under Save Settings to Local Hard Drive and then click the Reboot button under Reboot the CONCEPTRONIC C54BRS4A. The Router will save the new settings and restart. Upon restarting the Router will automatically establish the WAN connection. Additional settings for PPPoE/PPPoA connections: PPPoE/PPPoA Parameters User Name Description For PPP connections, a User Name and Password are used to identify and verify your account to the ISP. Enter the User Name for your ADSL service account. User names and passwords are case-sensitive, so enter this information exactly as given to you by your ISP. Together with the User Name, this is used to verify your account to the ISP. Enter the Password exactly as given to you by your ISP. The Maximum Transmission Unit size may be changed if you want to optimize efficiency for uploading data through the WAN interface. The default setting (1492 bytes) should be suitable for most users. Some user may want to adjust the setting to optimize performance for wireless traffic or when low latency is desired (such as with Internet gaming). It is highly recommended that the user research how adjusting the MTU may affect network traffic for better or worse. 35 Password MTU Conceptronic C54BRS4A IP Address User Manual If you have selected the Static PPPoE option, type in the global IP address used for your WAN interface. [. . . ] If the distribution and/or use of the Program is restricted in certain countries either by patents or by copyrighted interfaces, the original copyright holder who places the Program under this License may add an explicit geographical distribution limitation excluding those countries, so that distribution is permitted only in or among countries not thus excluded. In such case, this License incorporates the limitation as if written in the body of this License. The Free Software Foundation may publish revised and/or new versions of the General Public License from time to time. Such new versions will be similar in spirit to the present version, but may differ in detail to address new problems or concerns. [. . . ]