Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CONRAD FP260. We hope that this CONRAD FP260 user guide will be useful to you.
Lastmanuals help download the user guide CONRAD FP260.
Detailed instructions for use are in the User's Guide.
[. . . ] the module has a serial interface (RS232) for connection to a PC. Using this, a connection to the supplied FP260 PC software can be established. no part of the product may be modified or converted. The safety instructions must be observed. [. . . ] This procedure should take no less and no more than approx. If the fingerprint was memorized correctly, , , LED1" goes off and , , LED2" lights up. Position the same finger once again in the sensor casing until you hit the stop. Pull the finger out evenly over the sensor. This procedure should take no less and no more than approx. Position the same finger for the third time in the sensor casing until you hit the stop. Pull the finger out evenly over the sensor. This procedure should take no less and no more than approx. Pull the bridge off on jumper , , JP1". Now check whether the reading unit recognizes your master fingerprint. To do so, insert the just memorized master finger into the sensor until you hit the stop. Then , , LED1" and , , LED2" light up again. If the unit does not detect the master finger at the 1st or 2nd attempt (the relay does not click), delete the module data as described in , , Deleting the memorized fingerprints" and repeat the master fingerprint memory procedure. User fingerprint In order to memorize a new user fingerprint, the module first has to detect the master fingerprint successfully. Once the master fingerprint was detected successfully (section , , A"), you can program all other user fingerprints in sequence (section , , B"). 10 s , , LED1" goes off and , , LED3" lights up. Position the master finger as illustrated in the sensor casing until you hit the stop. Pull the finger out evenly over the sensor. This procedure should take no less and no more than approx. If the master fingerprint was successfully scanned, LED2 goes off and LED1 blinks briefly. Then LED 1 blinks to indicate that the system is ready to scan additional user fingerprints. Pull the finger out evenly over the sensor. [. . . ] Put the bridge onto jumper , , JP5" and wait approx. 20 seconds until , , LED2" lights up. â· After this time (and not before), all memorized fingerprints are deleted. â· Pull the bridge off of jumper , , JP5". [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CONRAD FP260
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CONRAD FP260 will begin.
