User manual CONSTRUCTA CP534V9

[. . . ] HQ 2SHUDWLQJ LQVWUXFWLRQV 9000 538 732 (9009) en Table of contents Additional options . Protection against frost (Emptying the appliance) . 14 14 14 14 14 14 14 15 15 15 15 16 16 16 16 17 17 18 18 18 19 19 20 21 21 21 21 22 22 22 22 23 23 23 23 23 23 Safety instructions . 7 Switching off water softening system . [. . . ] The end of the programme is also indicated by an acoustic signal. This function can be changed as follows: ­ Open the door. ­ Hold down programme button 3 and switch on the main switch (. To change the setting: ­ Press programme button 3. Each time the Programme button 3 is pressed, the buzzing sound changes in 4 stages (from off to loud). ­ Switch off main switch (, the set value is saved. ­ Close the door. 14 en Switching off the appliance Short time after the end of the programme: ­ Open the door. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. Terminating the programme (Reset) ­ Open the door. ­ Simultaneously press programme buttons # and 3 for approx. ­ Close the door. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Changing the programme After you have switched the appliance on, it is possible to change the programme within 2 min. If you want to change the programme afterwards, the appliance waits until the initiated programme section (e. washing) ends. Interrupting the programme ­ Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the main switch ( again. ­ Close the door. 15 en Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Filters The filters 1J keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. ­ After each wash cycle check the filters for residue and clean if required. ­ After unscrewing the coarse microfilter, you can take out the filter group. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. [. . . ] See rating plate for required fusing 9*. ­ The socket must be near the appliance and freely accessible following installation. ­ The connection may be modified by technicians only. ­ A power cord extension may be purchased from customer service only. [. . . ]