User manual CONTINENTAL EDISON FE5ECI2

[. . . ]  The Manufacturer highly recommends that this appliance be kept out of the reach of babies and small children. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. [. . . ] Observe the diameter of the fixing screws indicated in this manual. Do not modify the holes for securing the unit or its mounting bracket to the wall. Drill the wall with a drill of the appropriate size for the anchoring system. Regularly check the mounting points of the device on the wall. Before installing, make sure the unit is not plugged into an electrical outlet. The hood must be placed at least 70 cm above the hob. Drill 3 holes (8mm to adapt your wall plugs) to place the bracket. Screw and tighten the bracket to the wall with the screws 3 Screws (ST4x30mm) and 3 wall plugs (not supplied). Place the range hood and hook it by using the two notches on the wall bracket. (If the extraction installation mode is chosen) Place the Ø150-Ø153mm plastic pipe (supplied) on the air outlet as shown below. If the size of your plastic pipe is Ø120 - Ø123mm , you must firstly assemble the adapter to the air outlet, as shown below. Screw the lower chimney bracket on the lower chimney by using 2 screws(ST4x8mm). Install the lower chimney on the appliance, and mark the holes position on the wall. Remove the lower chimney, then drill holes in the wall: hole with diameter 4 mm screw. Install the lower chimney on appliance again, then screw it to the wall with 2 screws of diameter 4 mm and the corresponding wall plugs (not supplied). Also screw the chimney and the hood with 2 screws(ST4x8mm) step 8. Fix the upper chimney bracket on the upper chimney by 2 screws . Pull the upper chimney upwards to the target height and mark the holes on the wall. Release the upper chimney and then drill holes on the wall. Pull out the upper chimney again, then fix it to the wall with 2 screws ST4x30mm. Recycling Mode: If you do not have an outlet to the outside, plastic pipe is not required and the installation is similar to above. And you need to assemble the carbon filters which are used to trap odors. [. . . ] (4) Do not forget to turn off the range hood once cooking is complete. Disassembly Information Do not disassemble the unit in a manner that is not indicated in the operating instructions. This device must not be disassembled by the user. At the end of its life cycle, the appliance must not be disposed of with household waste. [. . . ]