User manual CONWIN 2002 BALLOON EXPLODERS

[. . . ] When running the line, make sure that it is free of kinks or sharp bends and follows only smooth curves. Use the Quick-Fit Tee Fittings to branch the air line in different directions. 2. Connect the Air Lines Quick-Fit Connecting Tee Quick Fit Connecting Splice Twin-Pin Exploder Cut the air line with scissors at each interval where an exploding balloon is required. Press the end of the air line into the QuickFit Connector until it reaches the back of the fitting, approximately 1/2 inch. [. . . ] This test insures the exploder is operating properly and the system is ready to install. If the pin remans in the out position, lightly press the pin on a hard surface to reset the unit. When using 20 or more exploders, tape 5-inch balloons to each exploder to test that system is working properly. When the detonator button is pressed, all the test balloons should pop. If not, confirm that the airline is properly attached to all fittings and retest the system. Deluxe Exploder Kit Cylinder Filling Instructions · Hand tight connect the regulator end of the transfill hose to a helium or nitrogen cylinder with a minimum of 500 PSI pressure. · Hand tight connect the other end to the small cylinder. · Open both valves, allowing the gas to automatically transfer between cylinders. Once it reaches 500 PSI, the small cylinder is full and the system will stop filling. · Close both cylinders and open the bleed valve to release the gas remaining in the transfill hose. · Hand tight connect the Exploder Regulator to the small cylinder. Bleed Valve Exploder Air Line 7. Tape The Exploders To the Balloon Position the exploder near the midsection of a fully inflated balloon. Use clear packing tape to attach each side of the exploder to the balloon. Important: Leave approximately 1/2" of space between the tape and the center upright point of the exploder. This allows the air to escape and pop the balloon when the exploder is detonated. After the exploder(s) have been taped to the balloon, use Dacron Archline to suspend the balloon from the ceiling. Tape the air line to the Dacron Archline. Make sure the weight of the balloon is supported by the archline and not by the air line. Packing Tape Twin Pin Balloon Exploder 8. Fully open the cylinder valve and verify there is a minimum of 500 PSI in the cylinder. [. . . ] Slide the air line through the cut to the center of the tab. Remove paper backing from the adhesive surface and press the tab to the ceiling track. B Twin Pin Exploders Our new versatile Twin Pin Exploder includes a removable plug enabling you to explode a single balloon or multiple balloons from one air line. Quick Fit connections on both sides allow you to easily connect to air line. On cue, two pins pierce and explode the balloon. [. . . ]