User manual CONWIN CONFETTI CANNONS

[. . . ] Confetti Cannon Kit Includes: Confetti Cannon Instruction Sheet Charging the Confetti Cannon 1 2 2 2 1 1 1 1 Confetti Cannons 100-Ft. Spools of Wire Two-Zone Control Box with 12-Volt Sealed Battery Control Box Battery Charger Cannon Recharge Regulator Carrying Case Vie w a de monstratio n of the Confetti C annon on Conwin's Tools of th e Trade DV D 3 4 Hand-tight connect the regulator to a helium or nitrogen cylinder. The cylinder must have a minimum of 1, 000 psi gas pressure to properly charge the cannon. Make sure the bleed valve on the regulator is closed before filling the cannon cylinder. Remove the cap from the filling outlet on the cannon. [. . . ] If using bundled confetti, be sure to remove the rubber bands before placing them in the barrel. To avoid confetti from clumping, do not tightly pack the confetti in the barrel. 2 Use a foil balloon to seal the barrel. Cut a 6" radius circle out of a foil balloon (Use a popped or scrap balloon). One circle will provide two pieces of foil material. Place one foil circle over the end of the barrel and screw the barrel into the cannon base. Rigging the Cannon 1 2 3 Firing the Cannon Firmly plug the lead wire into the cannon. 1. The rigging mount, located at the bottom of the barrel fits a 1/2" electrical conduit. Place the conduit into the mount and firmly tighten the thumb screw to secure the cannon in place. The angle of the cannon barrel can be adjusted to achieve different effects. Select the proper angle for the event and tighten the wing nut to hold the barrel in place. Use a heavy weight at the base of the column. Before loading the Confetti Cannon with confetti and covering the conduit with balloons, test fire the cannon prior to the event to insure the column is properly secured. Plug the detonator line into the cannon. The 100-foot spool of line is designed to remain on the orange holder­unwind only the necessary length needed to connect the cannon to the detonator box. On cue, push and hold down the Control Box detonator button until the cannon has completely fired. For best results, wait for approximately 2 seconds between pressing the first and second button. This will prolong the air time of the confetti. IMPORTANT: Prior to event, always verify that the battery is fully charged. To avoid accidentally firing the cannons, do not plug the wire into the Control Box until the event is ready to start. [. . . ] Is your portfolio up to date on the latest?Conwin's Portfolio Builder images are the perfect solution for making winning presentations to your clients. Thirty-two photo quality images are available in the full series. Visit www. ConwinOnline. com today! [. . . ]