User manual CONWIN HI-FLOAT INFLATOR

[. . . ] Hand tighten the primary regulator to the helium cylinder. 7 8 9 7. Press quick-fit connection on the helium supply line into the back of the unit. Slowly open the cylinder valve 5 full turns. 8. Plug the power cord and foot pedal into the side of unit. 9. [. . . ] There's a groove at the top of the outlet that will hold the balloon in place for hands-free operation. 3 Pinch neck 3. Tap the foot pedal to begin the automatic helium inflation process. Remove the balloon from the outlet and tie. Rub balloon Mode 3 Inflating Latex Balloons with Hi-Float® and Helium 1. Reference the size setting chart to verify the preset amounts of Hi-Float® and helium. Slide the neck of the balloon all the way over the inflating outlet. There's a groove at the top of the outlet that will hold the balloon in place for hands-free operation. Hi-Float® will enter the balloon first. After the Hi-Float® enters the balloon, pinch the neck of the balloon to prevent Hi-Float® from coating the outlet. Rub the balloon to evenly distribute the Hi-Float® and fully coat the inside of the balloon. After a 5 second delay the automatic helium inflation process begins. (NOTE: Tap the foot pedal twice to reduce the 5-second delay to 3 seconds. ) 4. Remove the balloon from the outlet and tie. Wipe off any excess Hi-Float ® from the aluminum outlet before replacing the blue outlet cap. For Mode 3 only 4 Troubleshooting: If the unit is not fully inflating balloons with helium, see the section on Inflator Maintenance on the back page of the instruction sheet. Settings Chart Mode 3 (Hi-Float® & Helium) Balloon Size Hi-Float Test Amount 1/2 tsp. 2+ tbsp. ® Adjusting Pressure The second-stage helium regulator should be set at 70 PSI. To adjust the pressure, pull the knob up -clockwise increases the pressure, counterclockwise decreases the pressure. Press the knob down to lock it in place. Mode 1 (Hi-Float®) seconds 1. 7 3. 4 11. 7 12. 3 Mode 2 (Helium) seconds 1. 8 3. 7 9. 7 13. 8 9" 11" 16" 18" Time settings are in seconds for both Hi-Float ® and Helium. Set the unit to Mode 1 to test the amount of Hi-Float ® injected placing the measuring cup under the outlet. IMPORTANT: HiFloat ® is temperature sensitive. Use this chart as a guideline and adjust as needed. Refilling the Reserve Cylinder When the Hi-Float ® level drops below the refill line on the sight tube, add 2 quarts of Hi-Float ®. 1 2 3 1. Press the silver release tab on the helium supply line to remove the line from the cylinder. Repeat this process with the Hi-Float ® supply line. 2. Open the pressure bleed valve on the HiFloat ® reserve cylinder cap to release the pressure from the cylinder. [. . . ] Table Clamp #32040 Counter Mount #32180 Under-Counter Ribbon Dispenser This ribbon dispenser mounts to the Countertop Helium Outlet of your Remote Helium Set-up. Conwin #49047 20-Spool Ribbon Rack A compact, freestanding unit, featuring two ribbon cutters. With the top feed organizer, you can pull all the ribbons up at the same time!Conwin #32100 V-Safe Helium Lock Monitor your helium use. [. . . ]