User manual CORBERO EX68B

[. . . ] ATTENTION: For the filtering version it is absolutely necessary to use the special charcoal filter whereas for the ducting version it is not. INSTALLATION Before assembling the appliance it is necessary to take off the anti-grease grille. To take off the grill it is necessary to push this one towards the rear of the apparatus, by means of the proper knobs, so that it gets released, and to pull it downwards; to take it off completely, make it rotate on one side keeping the other one steady (Fig. Installation in extraction version: depending on your requirements, choose which opening to use for the air outlet (rear or upper) and fit the flange (A) provided, proceeding as follows: make the 3 flange tabs and stop (C) coincide with the slots on the hood; turn the flange slightly clockwise until it locks into position (Fig. [. . . ] On the other opening, fit the cap (B) provided and make the 3 cap tabs and stop (D) coincide with the slots on the hood; turn the cap slightly clockwise until it locks into position. Installation in filter version: on both the openings (rear and upper), fit the caps (B) provided, making the 3 cap tabs and the stop (D) coincide with the slots on the hood; turn the cap slightly clockwise until it locks into position. The following operations are essential for assembly: Install a proper wiring system. If your apparatus is to be assembled as a Ducting appliance, you must first make the air venting hole and get a proper pipe to connect the hole to the flange of the hood. Wall fitting:Making use of the appropriate drilling jig, apply the supplied blocks into the wall. Insert two of the supplied screws so that the apparatus can be hooked onto these ones by means of the holes provided on the appliance (Fig. Once the apparatus is hooked, fix it definitively to the wall using the two other screws and the holes made at its bottom (Fig. 5B). 2F and 7F): lift the two stops made of metallic wire (Fig. 7C); insert the charcoal filter and set back the two stops. In case the hood is a filtering version one, it is necessary to change the charcoal filter (Fig. 2F and 7F) according to utilization about every six month. To remove the charcoal filter: take off the anti-grease grill: by means of the proper knobs make the grill move towards the rear of the apparatus and drop the front part of it; now, keeping the right (or left) side of the grill steady, make the opposite side rotate so that it gets off the hood (Fig. The anti-grease filtering panel is easily removed from the grille by opening it as described above and lifting the two stops made of metallic wire (Fig. In the filtering version, to get access to the anti-grease panel the charcoal filter must be removed too. [. . . ] The anti-grease filtering panel is easily removed from the grille by opening it as described above and lifting the two stops made of metallic wire (Fig. In the filtering version, to get access to the anti-grease panel the charcoal filter must be removed too. Change the anti-grease panel according to use. [. . . ]