User manual CORBERO FC1780S-9

[. . . ] Before installing and using the appliance read this user's instruction book carefully. it contains safety precautions , hints , information and ideas. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. The symbols below help you to find things more easily: Safety precautions Warnings and information at this symbol serve safety for you and your appliance. [. . . ] Symbols signify the various foods, numbers mean maximum storing time given in months. In this chapter practical hints and ideas are given about how to use the appliance to reach maximum energy saving and there is environmental information about the appliance as well. Bleeding part of the moisture of cooling chambers in form of frost and ice goes with the operation of the appliance. Thick frost and ice has an insulating effect, so it reduces cooling efficiency as the temperature increases in the cooling chambers, they need more energy, at a certain thickness it does not allow the door of the freezing compartment to open. At this type of appliance defrosting the cooling plate of the refrigerator is automatic without any external intervention. The thermostatic control interrupts the operation of compressor at regular intervals for more or less time - during this cooling is interrupted - the temperature of the cooling plate goes above 0 °C due to interior heating load of the compartment, so defrosting occurs. when the surface temperature of the cooling plate has reached +3 - +4 °C the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet leaded through the back into the evaporative tray maintained on the top of compressor and evaporates due to its warmth. Check and clean the outlet of melting water coming during defrosting regularly - a label inside the appliance warns you for this. If it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance. How to save energy Avoid putting the appliance in a sunny place and near anything that gives off heat. Be sure that the condenser and the compressor are well ventilated. Do not cover the sections where ventilation is. wrap products in tightly closing dishes or cling film to avoid building up unnecessary frost. Do not leave the door open longer than necessary and avoid unnecessary openings. Put foods into the appliance only in a closed dish. Put warm foods into the appliance only when they are at room temperature. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. The materials used on this appliance marked with the sympol are recyclable. [. . . ] It is recommended to ask another person for help, who can keep the appliance at this position safely. With a knife) the covering nails of screws fixing the bottom cover grid, then the cover grid can be removed by unscrewing the plate-screws (2 pieces). Dismount the bottom door holder of the freezer by removing the screws (2 pieces) and the fill plates (2 pieces). Unscrew the top door holding pin of the refrigerator, then screw it back on the other side. [. . . ]