User manual CORBERO FC1801I

[. . . ] REFRIGERADORCONGELADOR FRIDGE-FREEZER FC 1801 I LIBRO DE INSTRUCCIONES INSTRUCTION BOOKLET 2222 284-05 WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. General Safety s This appliance is designed to be operated by adults. [. . . ] 8 A Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. PR33 20m m 15 Fig. 9 8mm Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. PR34 Remove the little plates and make the holes with a diam. Replace the little platee over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. PR35 Fig. 10 If the appliance is fixed to the side of the kitchen unit, simply slacken the screws in the fixing brackets (G), move the brackets as shown in the figure and re-tighten the screws. Fig. 11 E D735 E The doors can be opened using the sliding system previously illustrated, or one of the two doors can be opened by fitting the small handle supplied as an accessory (see figure). Fig. 12 D029 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. 16 GB USE The control panel 21 GB This freezer has been marked with the symbol, which means that it is suited to the freezing of fresh foods, the conservation of frozen foods and the production of ice-cubes. SN O 6 5 ABC A. Thermostat knob D E thermostat knob with respect to the normal running position. Depress the ambient switch at least 3 hours before loading food to be frozen. However, for a quicker freezing operation, turn the thermostat knob to the coldest setting; but remember that, in this condition, the refrigerating compartment temperature might drop below 0°C. If this occurs reset thermostat knob to a warmer setting. To help you make the most of the freezing process, here are some important hints: Place the food to be frozen in the top basket of the freezing compartment as this is the coldest part. The maximum quantity of food which can be frozen in 24 hrs is shown on the rating plate. Only freeze top quality, fresh and thoroughly cleaned foodstuffs. [. . . ] Important If the ambient temperature is high, the thermostat knob is on the coldest setting (higher numbers) and the appliance is fully loaded, the compressor may run continuously, causing frost or ice to form 18 Fig. 13 D040 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes off, then reposition as required. Fig. 14 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. [. . . ]