User manual CORBERO FC260I

[. . . ] REFRIGERADOR CONGELADOR FRIDGE-FREEZER FC 260 I LIBRO DE INSTRUCCIONES 2222 283-02 INSTRUCTION BOOKLET CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 12 13 13 13 13 13 13 16 16 16 16 16 16 17 17 18 19 19 19 19 19 Installation . . Power connection . Cleaning the appliance's interior . . Starting-up and temperature regulation. Freezing fresh food and storage of frozen food . [. . . ] The supply lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. Fig. 1 Instructions for total built-in Door reversibility Right-hand opening Remove pins (P) and (P1). Left-hand opening Remove (P) from both sides and also remove the door. Remove centre hinge (A) and refit it on the opposite side. Refit the door and (P) on the left-hand side and remove (P1) from the right-hand side. Recess dimensions Height Depth Width 1580 mm 550 mm 560 mm P P A P1 D114 P1 13 To ensure adequate ventilation, allow the clearances shown in figure 2. 50-min. 2 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. Fig. cm 2 200 D027 D Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D388 C Press in the joint covers between the appliance and the kitchen unit. Fig. 6 D023 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 D098 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 A B D265 D339 14 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. [. . . ] During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to perform this operation when the appliance is empty. To carry out complete defrosting of the freezer compartment ( ) proceed as follows: D315 Fig. 17 Unplug the appliance from the power supply or set the thermostat on the «O» position. [. . . ]