User manual CORBERO FD3290I

[. . . ] REFRIGERADOR CONGELADOR FRIDGE-FREEZER FD 3290 I LIBRO DE INSTRUCCIONES 2222 282-03 INSTRUCTION BOOKLET CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 12 13 13 13 13 13 13 16 16 16 16 16 17 17 17 18 19 19 19 Installation . . Power connection . Cleaning the appliance's interior . . Starting-up and temperature regulation. [. . . ] The supply lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. Fig. 1 Instructions for total built-in Door reversibility Right-hand opening Remove the pins (A) and (B). Left-hand opening Remove pins (A) and (C) from both sides and the door. Remove the middle hinge and refit it on the opposite side. Refit the door and pin (A) on the left side. Housing's dimensions Height Depth Width 1580 mm 550 mm 560 mm A 1 C 2 3 B D501 D 13 For appropriate venting, follow indications in Fig. 2 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. Fig. cm2 200 D033 D Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D502 C Press in the joint covers between the appliance and the kitchen furniture. Fig. 6 D015 If after having carried out the operation described in the previous section there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 D503 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 A B D265 D353 14 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. [. . . ] 15 However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to carry out this operation when the appliance is empty. To carry out complete defrosting of the ( freezer compartment proceed as follows: ) Unplug the appliance from the power supply or set the thermostat to position «O». Remove the frozen foods and wrap them in several sheets of newspaper, then keep them in a cool place. Place a basin on the refrigerator compartment shelf underneath the drainage hole and pull the plug downward (Fig. [. . . ]