User manual CORBERO FDE3290B

[. . . ] Remove the lower door, sliding it out of the middle hinge; 4. Remove the pin, then mount these on the opposite side. Remove the two plugs of the door (where available), discovering the holes for the hinge pins, assemble them on the opposite side and refit the upper door; 8. reassemble the middle hinge on the opposite side; 9. [. . . ] if it still does not light up , change the bulb. The light bulb inside the refrigerator compartment can be reached as shown in the figure. When the appliance is not in use for long periods, take the following precautions: remove the plug from the wall socket; remove all food; defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells. Use the special cleaner provided, which you will find already inserted into the drain hole. The freezer compartment, however, will become progressively covered with frost. This should be removed with a plastic scraper, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: 1. Pull out the plug from the wall socket or turn the thermostat knob to the «O» setting; 2. Remove any stored food, wrap it in several layers of newspaper and put it in a cool place; 3. When defrosting is completed, dry the interior thoroughly and refit the plug; 5. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. Do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: Raise the shelf from the back, push it in the direction of the arrow until it is freed and remove the retainers. The freezer compartment is suitable for long term storage of commercially frozen food, and for freezing fresh food. To freeze fresh foods it is not necessary to change the setting of the thermostat knob. [. . . ] It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. [. . . ]