User manual CORBERO FE1240S-1

[. . . ] In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm (A). [. . . ] The light bulb inside the refrigerator compartment can be reached as follows: - unscrew the light cover securing screw. - unhook the moving part as shown in the figure. If the light does not come on when the door is open, check that it is screwed into place properly. Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. ¥ ¥ ¥ how often the door is opened; the quantity of food stored; location of appliance. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the ÇOÈ (STOP) position. To obtain the best performance: ¥ ¥ ¥ do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: ¥ room temperature; The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Dimensiones en mm Altura Ancho Profundidad 1240 550 600 To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. Never use metal objects for cleaning your appliance as it may get damaged. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. [. . . ] Refer to your local Service Centre, and always insist on genuine spare parts. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. ¥ The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Best performance is obtained with ambient temperature between +18¡C and +43¡C (class T); +18¡C and +38¡C (class ST); +16¡C and +32¡C (class N); +10¡C and +32¡C (class SN). [. . . ]