User manual CORBERO FE1400S/2

[. . . ] Cover the holes left open with the plugs contained in the documentation pack. In Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. Energy Efficiency class Net Fridge Capacity lt. [. . . ] When the appliance is not in use for long periods, take the following precautions: remove the plug from the wall socket; remove all food; defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells. Clean the inside with warm water and bicarbonate of soda. The light bulb inside the refrigerator compartment can be reached as shown in the figure. If the light does not come on when the door is open, check that it is screwed into place properly. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: · Room temperature; how often the door is opened; the quantity of food stored; location of appliance. To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. if the appliance has been transported horizontally , it is possible that the oil contained in the compressor ílows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow tlie oil to flow back in the compressor. During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. [. . . ] Solid ice should be allowed to thaw when defrosting the appliance. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Care should be taken when moving it Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. [. . . ]