User manual CORBERO FE1400S-6

[. . . ] Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Care should be taken when moving it Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. [. . . ] Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Warnings Use Cleaning the interior Operation Temperature regulation Fresh food refrigeration Movable shelves Positioning the door shelves Hints Hints for refrigeration Maintenance Periodic cleaning Periods of no operation Interior light 9 11 11 11 11 11 11 11 12 12 12 12 12 12 Defrosting Customer service and spare parts Technical information Installation Location Electrical connection Rear spacers Changing the opening direction of the door 13 13 14 14 14 14 15 15 Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: · Room temperature; how often the door is opened; the quantity of food stored; location of appliance. To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. For safety, store in this way only one or two days at the most. : these should be covered and may be placed on any shelf. Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided. Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. [. . . ] For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. [. . . ]