User manual CORBERO FL3310I

[. . . ] This appliance is designed for storing and freezing food, domestic use according to these instructions only. Specialised companies that are qualified to do so by the manufacturer must carry out service and repairs including repairing and changing the power cord. Accessory parts supplied by them should be used only for repairing. Otherwise the appliance can be damaged or can cause other damage or injury. [. . . ] Turn the thermostatic control knob according to the figure. This time the red lamp starts giving light, the compressor starts and cooling begins shortly. When the red light goes out the temperature is sufficient and the appliance is suitable for storing frozen and deep-frozen foods. Controlling the temperature The thermostatic controller interrupts the operation of the appliance automatically for more or less time depending on the setting then restarts it assuring the required temperature. 20 GB Setting the thermostat knob can be done practically with a coin. Turning the control knob clockwise cooling becomes more and more intensive. In the appliance -18 °C or lower temperature can be reached if the thermostat knob is set according to the figure. The thermostat can be switched off (0 position), which means breaking the circuit of the compressor i. e. The temperature coming about in the freezer is effected by not only the position of the thermostatic control and the ambient temperature, but frequency of door openings and the quantity of food put into it, etc. In maximum position of the thermostat - in case of increased demand e. g. during heatwaves the compressor may operate continually. This does not cause damages to the appliance. Freezing Freezing different products should always be done in the freezing compartment after proper preparing. Move the fast freezer switch to the right (yellow lamp gives light) 4 hours before freezing food in small quantity and about 24 hours before in case of products in bigger quantity. This is not trouble, but means normal operation. We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being nocurrent. That is why you must not touch the electrical parts of the appliance before removing it from the mains socket. Problem The appliance does not cool sufficiently The appliance cools too hard The appliance does not cool at all Possible cause Thermostatic control is set too low. Before freezing the appliance was not precooled sufficiently. Too many foods to be frozen were put in. The thermostatic control is set too high. Solution Set higher position. Set lower position. The appliance is noisy Plug is not connected to the mains socket Check if the connection is proper. There is no voltage in the mains socket. Check if the appliance stands stable (all the four The appliance is not supported properly. feet should be on the floor). Inasmuch as the advice does not lead to result, call the nearest brand-mark service. 24 GB Ins tr uctions f or the Ins t aller Technical data Model/Type Gross capacity (l) Net capacity (l) Width (mm) Height (mm) Depth (mm) Energy consumption (kWh/day) (kWh/year) Energy class, according to EU Standards Freezing capacity (kg/24h) Rising time (h) Rated power (W) Weight (kg) CV 850 S/9 (TT 120 F) 117 100 550 850 600 0. 90 329 C 16 17 120 39 Installing the appliance Transportation, unpacking It is recommended to deliver the appliance in original packaging, in vertical position considering the protective warning on packaging. After each transportation the appliance must not be switched on for approx. [. . . ] If levelling the appliance requires, these washers can be removed. Do not stand the appliance on a sunny place or close to a radiator or cooker. If it is unavoidable because of furnishing and the appliance has to be stood near a cooker take these minimum distances into consideration: In case of gas or electric cooker 3 cm must be left, when it is less put a 0, 5 - 1 cm non-flam insulation between the two appliances. In case of oil or coal-fired stove the distance must be 30 cm since they give off more heat. [. . . ]