User manual CORBERO FM1240S/2

[. . . ] AL ANU T M STE OOKLE E RVE HIS B E ONS EEP T C EA Y AND K L D REA FM 1100 S/2 (190****) FM 1240 S/2 (240****) FRIGRORIFICO CONGELADOR COMBINADO REFRIGERATOR- FREEZER COMBINATION ES GB MANUAL DE INSTRUCCIONES INSTRUCTION BOOK 200364188 SP/C/29-1. (02. ) GB Before installing and using the appliance read this user's instruction book carefully. It contains safety precautions, hints, information and ideas. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. The symbols below help you to find things more easily: Safety precautions Warnings and information at this symbol serve safety for you and your appliance. Hints, useful information Environmental information Symbol for ideas At this symbol ideas can be found according to food and its storing. From the Electrolux Group. [. . . ] If you remove the food right at this moment the paper will tear and it can cause clogging up in the outlet by getting into it. So you are asked to be careful - because of the above - when placing foods wrapped in paper into the appliance. during heatwaves, the refrigerator temporarily happens to operate constantly. During this the automatic defrosting is ineffective. Remaining small ice and frost stains on back plate of the fresh food compartment after defrosting period is not abnormal. The frozen food compartment can not be equipped with automatic defrosting set since the deep-frozen and frozen foods do not endure melting temperature. So the enclosed plastic scraper is for scraping off and removing frost and ice coating which possibly occurs in the frozen food compartment and on the sealing of the door. The tray in figure is not a piece of accessories to the appliance!When ice coating is so thick that it can not be removed with the plastic scraper, the frozen food compartment has to be defrosted (generally 2-3 times a year). Take the foods out of the frozen and fresh food compartment, wrap them into some layers of paper or cloth. Put them to a possible cool place while defrosting. Break the circuit of the appliance and leave the doors of frozen and fresh food compartment open. Continuously blot off the defrosting water by a soft cloth or sponge. After defrosting wipe the surfaces, apply voltage to the appliance and put the foods back to their places. It is recommended to operate the appliance at the highest position of the thermostatic control so that it can reach the proper storing temperature as soon as possible. Regular cleaning It is recommended to wash the inside of the refrigerator in 3-4 weeks time. Household cleaner or soap must not be used. After you made it no-current wash the appliance using lukewarm water and wipe it. Clean the magnet door rubber profile with clean water. After cleaning plug the appliance to the mains socket. 25 GB It is practical to clean and defrost the frozen food compartment at a time and when it is empty. Dust and dirt collected on the back of the refrigerator, condenser is recommended to be removed and clean the evaporative tray on top of the compressor once or twice a year. When the refrigerator is not in use Break the circuit of the appliance. Defrost and clean it as written before. In case the appliance will not be used for a long time follow these steps: Leave the door open to avoid a build up of air inside. Trouble shooting How to change the bulb Should the light fail to work you can change it as below: Break the circuit of the appliance. [. . . ] Put over the handle and the plastic nails on the other side. Put the appliance to its place, set it level and plug it into the mains socket. 29 GB Change of door opening direction of frozen food compartment After changing the outer door opening direction at this type it is necessary to remount the door of the frozen food compartment as well. Operations and their order can be seen in figure. Pull out the bottom pin holding the door of the frozen food compartment (1). Open the door and remove it from the frame carefully (2). Take the distance sleeve out of the door and replace it to the other side (3). Pull the top pin out of the frame and put it back on the other side (4). [. . . ]