User manual CORBERO FM1240S/O

[. . . ] AL ANU T M STE OOKLE E RVE HIS B E ONS EEP T C EA Y AND K L D REA LIBRO DE INSTRUCCIONES OPERATING INSTRUCTIONS FM 1240 S/0 (240**) FRIGORÍFICO REFRIGERATOR E GB 1279980 SP/C/24. (00. ) GB Before installing and using the appliance read this user's instruction book carefully. It contains safety precautions, hints, information and ideas. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. [. . . ] Set the defrost water collector into closed position. Pull out the plastic plug at the bottom of the collector. Put a dish under the outlet of the defrost water collector, then push the defrost button in the middle of the thermostatic control knob, which is on the left side of the fresh food compartment. Cooling is interrupted for the time of defrosting and is automatically restarted at the end of that. When it is finished put the plug of the defrost water collector back and set the defrost water collector as described above. Regular cleaning It is recommended to wash the inside of the refrigerator in 3-4 weeks time. Household cleaner or soap must not be used. After you made it no-current wash the appliance using lukewarm water and wipe it. Clean the magnet door rubber profile with clean water. After cleaning plug the appliance to the mains socket. It is practical to clean and defrost the frozen food compartment at a time and when it is empty. Dust and dirt collected on the back of the refrigerator, condenser is recommended to be removed once or twice a year. When the refrigerator is not in use Break the circuit of the appliance. Defrost and clean it as written before. In case the appliance will not be used for a long time follow these steps: Leave the door open to avoid a build up of air inside. 25 GB Trouble shooting How to change the bulb Should the light fail to work you can change it as below: Break the circuit of the appliance. Unscrew the plate screw fixing the lamp cover, then take the lamp cover off in the direction of arrow and the bulb can be changed. (Type of the bulb: Mignon 322, 230 V, 15 W, E 14 thread) After changing bulb replace the lamp cover, screw the plate screw and apply voltage to the appliance. The lack of light does not influence operation of the refrigerator. If something does not work During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). This is not trouble, but means normal operation. We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being nocurrent. That is why you must not touch the electrical parts of the appliance before breaking the circuit. Problem The appliance does not cool sufficiently Possible cause The thickness of the frost is greater than 5 mm on the cooling plate. Too many foods to be cooled were put in. The drip tray is in the closed position. [. . . ] Before refitting the handle drill the plastic nails on the other side of the door, then refit the handle and the plastic nails taken out of the bag on the opposite side. Put the appliance to its place, set it level and plug it into the mains socket. In case you do not want to perform the procedures above, call the nearest brand-mark service. Technicians will accomplish the refitting expertly for charge. 29 GB Change of the frozen food compartment door opening direction Structure of this appliance requires to change the opening direction of the frozen food compartment door. [. . . ]