User manual CORBERO LT 4400

[. . . ] Always insist on genuine Zanussi spare parts. INSTALLATION I GENERAL SAFETY I I I I Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Make sure that the appliance does not stand on its electrical supply cable. If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely. This tumble dryer is designed to be vented through to the open air. [. . . ] If the hose is completely squashed, the safety cut-outs with which the machine is fitted may operate. 6 Door reversal To make it easier to load or unload the laundry the door can be reversed. This operation must be carried out by qualified personnel. Operate as follows: - Remove the door by unscrewing the two screws (1) fastening the hinge to the cabinet (Fig. - Remove the safety catch (2) and the plug (3) by bending the two fastening tags (Fig. - Refit the safety catch (2) and plug (3) on the door by reversing their positions (Fig. - Remove the plastic plate (4) by unscrewing the two fastening screws (Fig. - Refit the plastic plate (4) on the opposite side (Fig. - Refit the door by screwing in the two screws (1) which fasten the door to the cabinet (Fig. B). 3 P0283 2 1 4 A 4 1 2 3 P0748 B Electrical connection This machine is designed to operate on a 220230 V, single-phase, 50 Hz supply. Check that your domestic electrical installation can take the maximum load required (2. 2 kW), also taking into account any other appliances in use. Connect the machine to an earthed socket, in accordance with current wiring regulations. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution. Stacking kit A special stacking kit is available through your dealer, to enable the mounting of the dryer on top of your washing machine. P0280 7 ENGLISH USE Control panel ALGODON Y LINO EXTRA SECO SECO PARA GUARDAR SECO PARA PLANCHAR SINTETICOS SECO PARA GUARDAR D SELECCION DEL TIEMPO 20-90 MIN. A B C BOTON REDUCCION TEMPERATURA BOTON DE EXCLUSION ALARMA BOTON START LUZ PILOTO DE SECADO LUZ PILOTO DE ENFRIAMIENTO LUZ PILOTO FIN DE PROGRAMA LUZ PILOTO PUERTA ABIERTA SELECTOR PROGRAMAS/ INTERRUPTOR MARCHA/PARADA MARCHA PROGRAMAS 1 23 45 67 8 9 10 1 Programme Chart This will help you to select the correct programme for drying. 7 End of Programme Light This light (red) comes on at the end of the drying programme and remains alight until the door is opened. This light will also remind you that the filter should be cleaned at the end of each drying cycle. 2 Low Temperature Button Press this button to reduce the temperature when drying particularly delicate items. To be used only when drying synthetics with the time controlled programme. 8 Open Door Light This light (red) flashes when the door is opened or not well closed. 3 Buzzer Off Button Press this button if you do not wish the buzzer to ring during the «anti-crease» phase. 9 Mains-On Light This lights up by selecting the programme or time and goes out when the programme selector dial is turned to «0». 4 Start Button Press this button for a few seconds to start the selected drying programme. If the door is opened during drying, this button has to be depressed after closing the door to allow the programme to continue. 10 Programme Selector Dial To set the machine to the selected programme or time, turn the dial until the letter or the time you want coincides exactly with the pointer. 5 Drying Light This light (green) indicates that the machine is performing the drying programme. 6 Cooling phase Light This light (green) will illuminate when the cooling phase is in operation. This ensures that no dust and dirt is left in the drum. 1. Load the laundry Open the door by pulling the catch forwards. Load the items one at a time, shaking them out loosely and close the door. Please check the laundry does not get caught between the door and filter. P0305 2. Select the drying time or the drying programme Turn the selector dial to the desired programme or time, the mains-on light illuminates. B M0023S 3. Select the required option and start the machine Depress Buzzer Off and/or Low Temp. [. . . ] All fabric loses fluff when drying but it goes unnoticed in the air. In a tumble dryer it simply collects in the filter. P0767 13 ENGLISH SOMETHING NOT WORKING? Problems which you can resolve yourself: PROBLEM I POSSIBLE CAUSE I I I I I The dryer does not start up The door is open. The start button has not been depressed. The drying programme or time has not been selected. [. . . ]