User manual CORBERO LV8010PB

[. . . ] The appliance which you have just purchased has been very accurately controlled throughout the entire manufacturing process. Nevertheless, should any problem arise during usage, whether it be during the warranty period, or when such period has expired, please directly contact your nearest Corberó Service Centre. The address and telephone number of said Centre can be easily found in the enclosed List or by looking in the telephone directory, under Corberó. Our Corberó Service Network is at your complete disposal, to serve you with maximum speed and efficiency, all you have to do is call. The products In order to obtain a good wash, it is necessary to use detergents specially designed for dishwashers. [. . . ] In order to carry out the following operations easily we recommend you to load the upper basket to the higher position. To move to the higher position proceed as follows: 1. Carefully lift the basket upwards (position A). Push slightly downwards (position B). RC07 A B C When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. To lower the basket to the original position 1. Carefully lift the basket upwards (position A), then push downwards (position C). After loading your machine always close the door, as an open door can be a hazard. 31 CES10en Use of detergent Only use detergents specifically designed for use in dishwashers. If using powder detergents proceed as follows: 1. Open the dispenser lid by pulling the catch (D). Add the detergent according to the recommendations in the programme chart. As all detergents are not the same, you should also consult the instructions on the packet. If the programme has a prewash add the required detergent over the lid of the dispenser. If you wish to interrupt the washing programme at any time press this button again. 2. Check that there is rinse aid and salt Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. 3. 9. At the end of the washing programme At the end of the programme the dishwasher will automatically stop. The On/Off indicator light remains on until the On/Off pushbutton is depressed. 10. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the "Washing programmes" chart. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working;if the door is opened however, a safety device ensures that the machine stops. Switch off the dishwasher by pressing the On/Off pushbutton and open the door. 5. 6. 7. Close the dishwasher door Set the programme Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. [. . . ] The locknut must be correctly fitted to avoid water leaks. Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter. [. . . ]