User manual CORBERO LV8020PM

[. . . ] The appliance which you have just purchased has been very accurately controlled throughout the entire manufacturing process. Nevertheless, should any problem arise during usage, whether it be during the warranty period, or when such period has expired, please directly contact your nearest Corberó Service Centre. The address and telephone number of said Centre can be easily found in the enclosed List or by looking in the telephone directory, under Corberó. Our Corberó Service Network is at your complete disposal, to serve you with maximum speed and efficiency, all you have to do is call. The products In order to obtain a good wash, it is necessary to use detergents specially designed for dishwashers. [. . . ] Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. Cutlery should be placed in the removable cutlery basket with the handles facing downwards. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. Mix spoons with other cutlery to prevent them from sticking together. UI04 30 CES08en The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the fold-down cup racks so that water can reach all surfaces. Light items (plastic bowls etc. ) should be loaded in the upper basket and arranged so they do not move. Before closing the door, ensure that the spray arms can rotate freely. US33 After loading your machine always close the door, as an open door can be a hazard. 31 CES09en Use of detergent Only use detergents specifically designed for use in dishwashers. If using powder detergents proceed as follows: 1. Open the dispenser lid by pulling the catch (D). Add the detergent according to the recommendations in the programme chart. 7. Close the dishwasher door Set the programme Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. 8. Start the programme Depress the On/Off pushbutton. The On/Off indicator light will come on and the machine will start. 35 SEQ09en Maintenance and cleaning Internal cleaning Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash programme without dishes using detergen. Cleaning the central filter (After each wash) Scraps of food may accumulate in the drain filter (A) and should be removed by rinsing the filter under running water. To remove the drain filter - simply pull it out by the handle. Once cleaned, refit the filter by pushing it back to its original position until it engages. A MA04 Cleaning the large filter (Every month) If necessary clean the large filter (B) on both sides under running water, using a brush. Remove the spray arm by pulling it upwards on one side. Turn the column (C) anticlockwise by 90° and then slide out the filter. Once cleaned refit it following the above instructions in reverse order. Ensure the filter is in its original position, the handle of the drain filter should be pointing towards the front of the appliance. 90° B C MA05 The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. 36 MAN01en External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. [. . . ] The locknut must be correctly fitted to avoid water leaks. Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter. [. . . ]