User manual CORBERO LV8930B

[. . . ] The appliance which you have just purchased has been very accurately controlled throughout the entire manufacturing process. Nevertheless, should any problem arise during usage, whether it be during the warranty period, or when such period has expired, please directly contact your nearest Corberó Service Centre. The address and telephone number of said Centre can be easily found in the enclosed List or by looking in the telephone directory, under Corberó. Our Corberó Service Network is at your complete disposal, to serve you with maximum speed and efficiency, all you have to do is call. The products In order to obtain a good wash, it is necessary to use detergents specially designed for dishwashers. [. . . ] Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. RC01 A After loading your machine always close the door, as an open door can be a hazard. 33 CES06en Use of detergent Only use detergents specifically designed for use in dishwashers. If using powder detergents proceed as follows: 1. Open the dispenser lid by pulling the catch (D). Add the detergent according to the recommendations in the programme chart. As all detergents are not the same, you should also consult the instructions on the packet. If the programme has a prewash add the required detergent over the lid of the dispenser. If using detergent in tablets proceed as follows: 1. For all programmes; place 1 tablet inside the detergent dispenser. For all programmes with prewash; place a portion of a further tablet on the lid of the detergent dispenser. Min = 15 g Max = 30 g D DE17 Insufficient quantities of detergent will produce poor washing results, whereas an excessive amount of detergent will not improve washing results and is also wasteful. Remove the spray arm by pulling it upwards on one side. Turn the column (C) anticlockwise by 90° and then slide out the filter. Once cleaned refit it following the above instructions in reverse order. Ensure the filter is in its original position, the handle of the drain filter should be pointing towards the front of the appliance. 90° B C MA05 The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. 38 MAN01en External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. [. . . ] Make sure that the socket and plug are compatible without having to use any type of adaptor. If necessary, have the domestic wiring system socket replaced. Safety standards require the appliance to be earthed. The manufacture accepts no liability for failure to observe the above safety precautions. This appliance complies with the following E. E. C. [. . . ]