User manual CORBERO MO180

[. . . ] This appliance is designed for storing and freezing food, domestic use according to these instructions only. Specialised companies that are qualified to do so by the manufacturer must carry out service and repairs including repairing and changing the power cord. Accessory parts supplied by them should be used only for repairing. Otherwise the appliance can be damaged or can cause other damage or injury. [. . . ] In the appliance -18 °C or lower temperature can be reached if the thermostat knob is set according to the figure. The thermostat can be switched off (0 position), which means breaking the circuit of the compressor i. e. The temperature coming about in the freezer is effected by not only the position of the thermostatic control and the ambient temperature, but frequency of door openings and the quantity of food put into it, etc. In maximum position of the thermostat - in case of increased demand e. g. during heatwaves the compressor may operate continually. This does not cause damages to the appliance. Freezing Freezing different products should always be done in the freezing compartment after proper preparing. Turn on the freezer switch (it moves outwards and the indicator lamp gives light) 4 hours before freezing food in small quantity and about 24 hours before in case of products in bigger quantity. This time the compressor operates continually to reach temperature necessary for freezing. Place the foods to be frozen in and operate the appliance as written for about 24 hours. After these turn off the freezer switch (push it and the lamp will go out) and the appliance will operate again in automatic mode. Never freeze food in bigger quantity than given in the Technical data at the same time, otherwise freezing will not be thorough and after dissolving various deterioration may take place (losing taste and aroma, lysing, etc. ). Leave the door open to avoid a build up of air inside. Problem The appliance does not cool sufficiently The appliance cools too hard The appliance does not cool at all Possible cause Thermostatic control is set too low. Before freezing the appliance was not precooled sufficiently. Too many foods to be frozen were put in. The thermostatic control is set too high. Plug is not connected to the mains socket properly. There is no voltage in the mains socket. The appliance is not supported properly. Solution Set higher position. Check if the appliance stands stable (all the four feet should be on the floor). The appliance is noisy Inasmuch as the advice does not lead to result, call the nearest brand-mark service. 24 GB Ins tr uctions f or the Ins t aller Technical data Model/Type Gross capacity (l) Net capacity (l) Width (mm) Height (mm) Depth (mm) Energy consumption (kWh/24h) (kWh/year) Energy class, according to EU standards Freezing capacity (kg/24h) Rising time (h) Rated power (W) Weight (kg) Number of compressors CV 1600 S/9 (ZLFF 230) 230 190 600 1630 600 1, 18 431 C 25 24 130 62 1 Installing the appliance Transportation, unpacking It is recommended to deliver the appliance in original packaging, in vertical position considering the protective warning on packaging. After each transportation the appliance must not be switched on for approx. Unpack the appliance and check if there are damages on it. Report possible damages immediately to the place you bought it. [. . . ] The refrigerator is designed to operate when it is totally pushed to the wall. When placing the refrigerator keep minimal distances recommended in figure. A: placing it under a wall-cupboard B: placing it freely 26 GB Change of door opening direction Should the setting-up place or handling demand it, door-opening direction can be refitted from righthanded to left-handed. Appliances on the market are right-handed. [. . . ]