User manual CORBERO MO19GM

[. . . ] This appliance is designed for storing and freezing food, domestic use according to these instructions only. Specialised companies that are qualified to do so by the manufacturer must carry out service and repairs including repairing and changing the power cord. Accessory parts supplied by them should be used only for repairing. Otherwise the appliance can be damaged or can cause other damage or injury. [. . . ] The temperature coming about in the freezer is effected by not only the position of the thermostatic control and the ambient temperature, but frequency of door openings and the quantity of food put into it, etc. In maximum position of the thermostat - in case of increased demand e. g. during heatwaves the compressor may operate continually. This does not cause damages to the appliance. Freezing Freezing different products should always be done in the freezing compartment after proper preparing. Turn on the freezer switch (it moves outwards and the indicator lamp gives light) 4 hours before freezing food in small quantity and about 24 hours before in case of products in bigger quantity. This time the compressor operates continually to reach temperature necessary for freezing. Place the foods to be frozen in and operate the appliance as written for about 24 hours. After these turn off the freezer switch (push it and the lamp will go out) and the appliance will operate again in automatic mode. Never freeze food in bigger quantity than given in the Technical data at the same time, otherwise freezing will not be thorough and after dissolving various deterioration may take place (losing taste and aroma, lysing, etc. ). Do not make ice during freezing preferably, because making ice reduces freezing capacity. 21 GB Storing It is practical to replace frozen products into the storing compartments (cages) after freezing has finished so that to make room in the freezing compartment for another freezing. Intermediate freezing does not deteriorate foods already stored. Hints and ideas In this chapter practical hints and ideas are given about how to use the appliance to reach maximum energy saving and there is environmental information about the appliance as well. How to make ice cubes How to save energy Avoid putting the appliance in a sunny place and near anything that gives off heat. In the following chart information is given about them to avoid unnecessary charges on service. We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). This is not trouble, but means normal operation. We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being nocurrent. That is why you must not touch the electrical parts of the appliance before breaking the circuit. When the refrigerator is not in use In case the appliance will not be used for a long time follow these steps: Break the circuit of the appliance. Leave the door open to avoid a build up of air inside. Problem The appliance does not cool sufficiently The appliance cools too hard The appliance does not cool at all Possible cause Thermostatic control is set too low. Before freezing the appliance was not precooled sufficiently. Too many foods to be frozen were put in. The thermostatic control is set too high. Plug is not connected to the mains socket properly. There is no voltage in the mains socket. [. . . ] The refrigerator is designed to operate when it is totally pushed to the wall. When placing the refrigerator keep minimal distances recommended in figure. A: placing it under a wall-cupboard B: placing it freely 26 GB Change of door opening direction Should the setting-up place or handling demand it, door-opening direction can be refitted from righthanded to left-handed. Appliances on the market are right-handed. [. . . ]