User manual CORONA CONCEPTS BUTTERCUP

[. . . ] Corona Concepts presents The Buttercup All Wood Dollhouse Instructions and Assembly Guide Introduction In Short . . Welcome to the exciting world of dollhouses and miniatures. Since the first tab and slot die-cut dollhouse kits arrived on the scene in the mid 1970's, their design and styling concepts have evolved swiftly. However, complexity of construction has always accompanied the great design and styling. [. . . ] R&P first floor (1), second floor (2), left side (3), right side (5), front left and right (6), front entry left (8), front entry right (9), front entry wall (7). Using tabs and slots, align left and right walls to first and second floors - (G). Align left front wall to front edges of first and second floor - (G). Align right front wall to front edges of first and second floor - (G). R&P first floor support (5), second floor support (7). Align first floor support under bottom edge of first floor and flush with left and right sides - (G) Align second floor support under bottom edge of second floor and flush with left and right sides - (G) B) ASSEMBLY OF BAY 1. R&P left and right bay sides, (4), bay floor (4), bay window seat (6), bay cupboard (6), two bay cupboard doors (6), bay front (7). Align bay window seat to left bay side - NOTE THAT THE OUTSIDE EDGES MUST BE FLUSH. Align right bay side to bay floor and seat - (G). Align this entire assembly to right side of house - (G). Align bay front to front edges of bay sides - (G). From inside of house align bay cupboard under window seat (G). R&P three interior window sashes (3, 5, 6) and three interior window casings (3, 5, 6). Remove three windows from plastic window sheet by cutting along the dotted lines with sharp scissors. With all 3 sashes face down, position plastic windows centered on the sashes - (G). Align window sashes over bottom half of window openings - (G). Align the interior window casings around the interior sashes - (G). R&P three round interior window casings (4, 5, 7) casings to appropriate windows (G). Align Remember to use white glue when assembling plastic windows! 3. R&P two interior front entry window casings (5). Align casings to inside of front entry left and right walls window openings - (G). A foam brush works best for staining! 4. R&P three exterior window sashes (5, 7, 8), three exterior window casings (5, 7, 8), and three exterior window gingerbread trims (8). [. . . ] Align right gable roof to front roof and entry front(G). Align left gable roof to front roof and entry front-(G). Position smaller gable trim under gable roof-(G). Position gable trim to front and back roof on right and left side-(G). [. . . ]