User manual CORONA CONCEPTS CREEKSIDE CABIN

[. . . ] Corona Concepts presents The Creekside Cabin All Wood Dollhouse © 1997 Corona Concepts Schenevus, NY 12155 All rights reserved These instructions were printed in New York State Instructions and Assembly Guide Introduction In Short . . Welcome to the exciting world of dollhouses and miniatures. Since the first tab and slot die-cut dollhouse kits arrived on the scene in the mid 1970's, their design and styling concepts have evolved swiftly. However, complexity of construction has always accompanied the great design and styling. [. . . ] With the porch roof face down, position and glue the column support centered from side to side and 1" from the front side. Rest the porch roof on the fourteenth log of the house and glue in place. The porch columns should rest against the front edge of the column support on the underside of the roof and should be glued in place. Finishing Touches Finishing your dollhouse is only limited by your imagination. Paint, wallpaper, stain and stucco are only a few of the items you can be creative with. Wood fill and primer can be very helpful. Use the wood fill to smooth joints between tabs and slots and on corner seams. Primer is recommend to prime the wood with before painting. Parts to be stained should NOT be primed. Satin finish latex house paint will give a better result than either flat or gloss finish. Be sure to check your local craft shop for other decorative items such as siding, floor tiles, carpet, electrification kits, furniture, etc. 5. Position and glue the porch brackets in place using the K) FRONT DOOR AND DOOR TRIM ?R&P three pieces of exterior front door trim from sheets #1 and #1A. R&P three pieces of interior front door trim from sheet #7. Position and glue the exterior door trim pieces flush to the door opening. Position and glue the interior door trim pieces flush to the door opening. R&P four door planks from sheet #1A. R&P three door braces from sheet #1. Position and glue the four door planks side by side with top and bottom edges flush. Using the photo as a guide, position and glue the door braces to the front side of the door. Glue the door into position in the front door opening. The Creekside Cabin 3 8 The Creekside Cabin Assembly Instructions H) STAIRS AND 2ND FLOOR RAILINGS ?Evenly space the stair treads at a 45° angle. Glue the second stair tread on top of the treads. [. . . ] Save all of the little ¾" squares ­ you should have 22 from this sheet and prepare them to match the outside of your house. R&P right side of house located on sheet #3. Save all of the little ¾" squares ­ you should have 22 from this sheet and prepare them to match the outside of your house as well. Prepare the 20 ¾" squares you saved from section "D" to match the outside of your house ? [. . . ]