User manual CORONA CONCEPTS SHADY BROOK CABIN

[. . . ] We feel you will find that this kit will be an enjoyable and rewarding project. If you are just beginning to discover the wonderful world of miniatures, we hope that the simplicity of this kit will be a pleasant introduction to the craft. If you are an experienced veteran, we hope you will appreciate the simple, straight forward construction and design. Before beginning assembly, please read through all of the instructions carefully. [. . . ] Each ¾" square should be flush with the log you are gluing it to. This forces the side wall tight to the front wall and eliminates the need to actually glue the walls together. Slide the first floor into position over top of the first floor supports ­ glue in place. Slide the second floor into postion over top of the second floor supports - glue in place. Position the first floor back support along the under side of Before You Begin THIS KIT CONTAINS: w w w Nine pre-cut wood sheets One set of instructions One set of schematic diagrams ITEMS YOU NEED TO SUPPLY w w w w w w w w Lead pencil and eraser Emery board Newspapers or other drop cloth Extra sandpaper Ruler or other straight edge Wood filler Stiff bristled brush Glue ( We recommend that you use a hot melt glue gun and glue sticks. You can assemble the house with white or household glue, however items will need to be clamped or otherwise held tight while the glue dries. This slows down overall construction time considerably. ) If anything is missing, contact us at (800) 253-7150! Hot melt glue and glue guns may be found at your local hardware or craft store! Tips for Success! 1. Save the kit box as a safe "nest " for the wood sheets until all the parts have been removed from them. Also the photos on the outside of the box may be useful as a reference tool. Set your work area up on a large flat surface with all of your supplies at hand. Consider an area that does not have to be "cleared" every day. Your project will take some time and if assemblies can remain in place until the paint or glue dries, it will be to your advantage. Do NOT jump ahead or A well lit work area will work best! 4. Only remove parts from the pre-cut wood sheets as they are called for in the instructions. If there are parts that for any reason are removed from the sheet but not called for yet, write the sheet number on the cut out and re-file or tape the piece to the rest of that sheet. When removing pieces from the pre-cut sheets, do so with extreme care. Some of these items are very detailed and somewhat fragile. The schematic diagrams are labeled with the sheet number, part's names, part's orientation (i. e. , left, right, interior, exterior, etc. ). It is helpful to write in pencil, this information on the pieces before removing them from the sheets. All markings can easily be erased later. E) ASSEMBLY OF BACK WALLS ?R&P two back walls ­ one from sheet #1 and one from sheet #1A. Remember to save all of the little ¾" squares ­ you should have 6 from each sheet. [. . . ] Be sure to check your local craft shop for other decorative items such as siding, floor tiles, carpet, electrification kits, furniture, etc. 1. With the front wall of the house face up, glue the window box back underneath the window opening as if it were the window trim bottom. Glue the window box bottom in place keeping it flush with the bottom edge of the back. Glue the side pieces in place and then finish with the front piece. [. . . ]