User manual CRAFTSMAN 138.74544

[. . . ] This product is warrantied against any defects in material or workmanship. For safe operation, read and understand all instructions before using this product. Failure to follow all safety instructions listed below, can result in serious personal injury. Do not allow children or untrained individuals to use this unit. [. . . ] An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Unit is designed for line trimmer use only. Use of any other accessories or attachments will increase the risk of injury. ) which can be thrown or become entangled in cutting head. Keep the air vents clean and free of debris to avoid overheating the motor. Stop the unit and disconnect the power source when not in use. Store unplugged and out of the reach of children. Do not hang unit so that the switch trigger is depressed. Never carry the unit by the extension cord or yank extension cord to disconnect unit. Keep the extension cord clear of operator and obstacles at all times. Do not expose cords to heat, oil, water, or sharp edges. If the power supply cord is damaged, it must be replaced only by the manufacturer or by an authorized service center to avoid risk. Refer to them frequently and use them to instruct others who may use this power tool. If you loan someone this power tool, loan them these instructions also. T im e Type of current Type or a characteristic of current Double-insulated construction Do not expose to rain or use in damp locations To reduce the risk of injury user must read and u n d e r s t a n d o p e r a t o r 's m a n u a l b e f o r e u s in g t h is p ro d u c t. Always wear safety goggles or safety glasses w it h s id e s h ie ld s a n d , a s n e c e s s a r y , a f u ll f a c e s h ie ld w h e n o p e r a t in g t h is p r o d u c t . When working outdoors with a product, use an extension designated with "WA" on the cord's jacket. Before using any extension cord, inspect it for loose or exposed wires and cut or worn insulation. Keep the extension cord clear of the working area. Position the cord so that it will not get caught on lumber, tools, or other obstructions while you are working with a power tool. Failure to do so can result in serious per sonal injury. Never use cord since touching the damaged area could cause elec trical shock resulting in serious injury. [. . . ] If there is no change in the cutting line length, un-plug the trimmer's pigtail power cord from the extension cord. After the trimmer head stops rotating, gently pull at the cutting lines manually. Once the lines are pulled out (extended), plug the trimmer's pigtail power cord into the extension cord and resume cutting. If the cutting line still does not feed from the spool, the spool might be empty or the cutting line may be tangled or jammed on the spool. [. . . ]