User manual CREATIVE GIGAWORKS T20 QUICKSTART BACK

[. . . ] The displayed content will disappear after 40 seconds. It can be displayed up to three (3) times. Make sure to adjust the resolution of your PC before reaching the maximum count. Note The resolution displayed on the screen is the optimal resolution for this product. [. . . ] Note When connecting a device to the DOWN port of the monitor, connect the device using a cable appropriate to the device. (For the purchase of the cable and external devices, ask the service center of the corresponding product. ) Connections The company is not liable for problems or damages to an external device caused by using an unauthorized cable for the connection. Some products do not follow the USB standard, and it may cause a malfunction of the device. If the device malfunctions even if it is connected to the computer, contact the service center of the device/computer. Using the Stand Monitor Assembly Simple Stand Monitor and Bottom HAS Stand Connections A. Stand Stopper Attaching a Base This monitor accepts a 100 mm x 100 mm VESA-compliant mounting interface pad. Simple Stand A. Mounting interface pad (Sold separately) 1. Turn off your monitor and unplug its power cord. HAS Stand Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the screen. Remove two screws and then remove the stand from the LCD monitor. Align the mounting interface pad with the holes in the rear cover mounting pad and secure it with four screws that came with the arm-type base, wall mount hanger or other base. · · · Do not use screws longer than the standard dimension, as they may damage the inside of the Monitor. For wall mounts that do not comply with VESA standard screw specifications, the length of the screws may differ depending on their specifications. Check the power cord connection and supply. Can you see "Check Signal Cable" on the screen?(Connected using the D-sub cable) Check the signal cable connection. Q: A: If the power is on, reboot the computer to see the initial screen (the login screen), which can be seen. If the initial screen (the login screen) appears, boot the computer in the applicable mode (the safe mode for Windows ME/XP/2000) and then change the frequency of the video card. (Refer to the Preset Timing Modes) If the initial screen (the login screen) does not appear, contact the Service Center or your dealer. Q: A: A: A: Can you see "Not Optimum Mode", "Recommended Mode 2048 x 1152 60 Hz" on the screen?You can see this message when the signal from the video card exceeds the maximum resolution and frequency that the monitor can handle properly. Adjust the maximum resolution and frequency that the monitor can handle properly. If the display exceeds SXGA or 75 Hz, a "Not Optimum Mode", "Recommended Mode 2048 x 1152 60 Hz" message is displayed. If the display exceeds 85 Hz, the Troubleshooting display will work properly but the "Not Optimum Mode", "Recommended Mode 2048 x 1152 60 Hz" message appears for one minute and then disappears. [. . . ] Adjust the resolution and frequency of the video card. Troubleshooting (Refer to the Preset Timing Modes). LED is blinking but no images on the screen. Q: A: Is the frequency properly adjusted when checking the Display Timing on the menu?Adjust the frequency properly by referring to the video card manual and the Preset Timing Modes. (The maximum frequency per resolution may differ from product to product. ) There are only 16 colors shown on the screen. The screen colors have changed after changing the video card. Q: A: Have the Windows colors been set properly? [. . . ]