User manual CREDA HB17021

[. . . ] Always take care to avoid heat/steam burns when operating the controls. Always turn off the electricity supply at the wall switch and allow the appliance to cool before cleaning . Always keep the appliance clean as a build up of grease or fat from cooking can cause a fire. Always follow the basic principles of food handling and hygiene to prevent the possibility of bacterial growth. [. . . ] Never use the appliance as a room heater. Never use misshapen pans which may be unstable. Never use round base woks directly on the pan supports. Never use fish kettles or large preserving pans across two burners. NOTE: The use of a gas cooking appliance results in the production of heat and moisture in the room in which it is installed. Always ensure that the kitchen is well ventilated; keep natural ventilation holes open or install a mechanical ventilation device (mechanical extractor hood). In particular, when using the grill or more than one hotplate burner, open a window if a mechanical ventilation device is not operating. 5 FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 6 USING THE GAS HOB - FEATURES In order to obtain maximum performance from the burners, use pans with the following diameters: Rapid burner 22 - 28 cm Standard burner 14 - 22 cm Auxillary burner 10 - 14 cm All pans should be positioned centrally over the burners. DO NOT allow young children near to the appliance when the hob is in use as the surfaces get extremely hot. OPERATION WHEN USING THE GAS HOB Step 1 Step 2 Step 3 Step 4 Step 5 Check that the electricity is switched ON. Press the ignition button and then push and turn the control knob of the chosen burner anticlockwise to the large flame symbol. Turn the control knob anticlockwise to the desired setting. Only turn the control knob between the large flame symbol and the small flame symbol when adjusting the setting. Place the pan centrally on the required burner. To switch off, turn the control knob fully clockwise. 6 FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 7 CARE AND CLEANING SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CLEANING. The wire which is coloured blue must be connected to the terminal which is marked with the N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. As the appliance must be earthed, do not use 2-pin sockets outlets, if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size i. e. 0. 75mm2 cross sectional area and temperature rating of 850 C e. g. IF A MOULDED PLUG IS FITTED In the event of replacing a fuse in the plug supplied a 3 amp ASTA approved fuse to BS1362 must be fitted. NOTE: The fuse cover must be refitted when changing the fuse. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been obtained and fitted. A new fuse cover can be obtained from your local Electricity Board. [. . . ] a drawer), does not pass through a space where it is likely to become trapped or damaged and hangs freely downwards. The temperature rise of the area of the base panel likely to come into contact with a flexible hose does not exceed 70ºC Connection must be by rigid pipework when the hob is installed above an oven. Put the burner rings and caps into position. Connect the hob to the electrical supply (see INSTALLATION - Electrical Requirements). [. . . ]