User manual CREDA HB41302

[. . . ] Inside the pack containing this manual, you will also find the guarantee and all the details necessary for installation. If the appliance is levelled correctly, it will be more stable and much less likely to cause vibrations and noise while it is operating, particularly during the spin cycle. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washing machine. Connecting the electricity and water supplies Connecting the water inlet hose ! [. . . ] Once the set delay time has elapsed, the machine will begin its cycle and the display will show “Ends in:” and the time remaining until the end of the cycle. To remove the delayed start option, press the button until the display shows the text OFF; the symbol will disappear. € Press the button to activate the option; the name of the option will then appear on the display and the corresponding indicator light will illuminate. € Press the button again to deactivate the option; the name of the option will then appear on the display followed by the text OFF, and the corresponding indicator light will switch off. If the selected option is not compatible with the selected wash cycle, this incompatibility will be signalled by the flashing of the indicator light and a sound alert (3 beeps); the option will not be activated. Cycle speed Fabric load duration (°C) (rpm) Prewash Wash Bleach softener (kg) 40° 60° 40° 60° 40° 30° 40° 30° 60° 60° 30° 40° 30° 90° 60° (Max. 90°C) 1400 800 800 1400 1400 800 600 1200 1400 1400 1400 1400 0 800 800 1400 1400                                         10 5 5 6 6 6 2, 5 3, 5 10 10 10 6 1 2, 5 4 10 10 (*) The duration of the wash cycles can be checked on the display. EN The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. (*) Note: 10 minutes after the START, the machine will recalculate the time remaining until the end of the wash cycle on the basis of the load inside it; this value will then be shown on the display. For all Test Institutes: 1) Test wash cycle in compliance with regulation 2010/1061: set wash cycle with a temperature of 60°C. Measuring out the detergent carefully will avoid wastage and help to protect the environment: although they are biodegradable, detergents still contain ingredients which alter the balance of nature. We recommend the following: • use powder detergents for white cotton garments and pre-washing. € use liquid detergents for delicate cotton garments and for all low-temperature wash cycles. € use gentle liquid detergents for wool and silk garments. The detergent should be poured into the relevant compartment - or the dispenser placed directly inside the drum - before the wash cycle begins. In the latter case, it will not be possible to select the Cottons with pre-wash cycle. Do not use hand washing detergents because these create too much foam. We recommend that duvets are placed in the drum with their edges folded inwards (see figure) and that no more than ¾ of the total volume of the drum is used. To achieve the best results, we recommend that a liquid detergent is used and placed inside the detergent dispenser drawer. Preparing the laundry • Shake out the garments before loading them into the machine. € Divide the laundry according fabric type (symbol on the washing instruction label) and colour, making sure you separate the coloured garments from the white ones; • Empty all pockets and check the buttons; • Do not exceed the values listed in the “Table of wash cycles”, which refer to the weight of the laundry when dry. [. . . ] • • • • The washing machine door remains locked. The machine continuously fills with water and drains. € If you have selected the function, at the end of the cycle the washing machine drum will rotate slowly; to end the cycle press the START/PAUSE button or the button. € The drain hose is not fitted at a height between 65 and 100 cm from the floor (see “Installation”). [. . . ]